User manual TRENDNET TEW-649UB

[. . . ] Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] 6 IDENTIFYING EXTERNAL COMPONENTS LED LED Status Slow Blink (1 blink/second) Description When the LED is blinking, the WLAN Adapter is transmitting or receiving data on the Wireless Ethernet network. After pressing the WPS button, the LED will flash 3 blinks/second. Once the connection is successfully established between the AP and the adapter, the LED Fast Blink (3 blinks/second) will remain solid for 5 seconds to tell the users that the connection has been established. After 5 seconds , the LED will turn off to indicate that the AP is ready for a new WPS connection and the adapter is associated with the AP. User inserts the card into the NB without driver installed, and without connection. Although the phone may not be in use, the base can still transmit wireless signal. Move the phone's base station as far away as possible from your wireless devices. If you are still experiencing low or no signal consider repositioning the wireless devices or installing additional access points. The use of higher gain antennas may also provide the necessary coverage depending on the environment. 8 SOFTWARE INSTALLATION This section describes how to install the driver and utility for the Wireless N USB Adapter. Windows Based Utility Installation 1) Insert the Utility and Driver CDROM into your computer's CDROM drive and then click Install Utility. 2) Follow the InstallShield Wizard Instructions 9 3) Click Finish. 4) Plug the Wireless N USB Adapter into an available USB slot on your computer. Driver Installation Windows Vista 1) Drivers will install automatically. Windows XP 1) The Found New Hardware Wizard appears Select No, not this time and then click Next. 10 2) Select Install this software automatically (recommended and then click Next. 13 WIRELESS UTILITY SETTING The user can configure the wireless settings using the Wireless Adapter Configuration Utility. The Wireless Adapter Configuration Utility is divided into six sections: Link Info, Configuration, Site Survey, Profile, WPS and About. Link Information This is the default screen after launching the Utility program. Status: Shows the associated BSSID (MAC address), which can be used to identify the wireless access point or router that you are connecting to. SSID: Shows the current SSID, which must be the same as your wireless access point or router in order to establish the connection correctly. Frequency: Shows the current frequency used for your wireless network. [. . . ] If a product does not operate as warranted during the applicable warranty period, TRENDnet shall reserve the right, at its expense, to repair or replace the defective product or part and deliver an equivalent product or part to the customer. The repair/replacement unit's warranty continues from the original date of purchase. All products that are replaced become the property of TRENDnet. TRENDnet shall not be responsible for any software, firmware, information, or memory data of customer contained in, stored on, or integrated with any products returned to TRENDnet pursuant to any warranty. [. . . ]