User manual TRENDNET TEW-648UBM

[. . . ] Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] The Micro Wireless N USB Adapter provides users with access to realtime information anywhere in their organization. The mobility of the Micro Wireless N USB Adapter provides productivity and service, which are not available under wired networks. The Micro Wireless N USB Adapter can easily adapt from peerto peer networks, suitable for a small number of users, to full infrastructure networks of thousands of users that allow roaming around a broad area. 6 UNPACKING AND SETUP This section provides unpacking and setup information for the Micro Wireless N USB Adapter. Unpacking The box should contain the following items: TEW648UBM Micro Wireless N USB Adapter MultiLanguage Quick Installation Guide CDROM (Utility & Driver) If any item is found missing or damaged, please contact your local reseller for replacement. System Requirements Before installation, check the following: Make sure your computer is running at least a 300MHz or above processor with 256MB RAM or above Make sure the USB ports are is USB 2. 0 port The operating system on your computer must be the following: XP (Service Pack 2), Windows Vista, Windows 7 802. 11n or 802. 11b/g access point or router. If you are still experiencing low or no signal consider repositioning the wireless devices or installing additional access points. The use of higher gain antennas may also provide the necessary coverage depending on the environment. 9 SOFTWARE INSTALLATION This section describes how to install the driver and utility for the Micro Wireless N USB Adapter. Windows Based Utility Installation 1) Insert the Utility and Driver CDROM into your computer's CDROM drive and then click Install Utility. 2) Follow the InstallShield Wizard Instructions 10 3) Click Finish to restart the computer. 4) After the computer is rebooted, plug the Micro Wireless N USB Adapter into an available USB slot on your computer. 11 WIRELESS UTILITY SETTING The user can configure the wireless settings using the Wireless Adapter Configuration Utility. The Wireless Adapter Configuration Utility is divided into six sections: Link Info, Configuration, Site Survey, Profile, WPS and About. Link Information This is the default screen after launching the Utility program. Status: Shows the associated BSSID (MAC address), which can be used to identify the wireless access point or router that you are connecting to. SSID: Shows the current SSID, which must be the same as your wireless access point or router in order to establish the connection correctly. Frequency: Shows the current frequency used for your wireless network. Link Quality: Shows the link quality of the Micro Wireless N USB Adapter with the Access Point when operating under Infrastructure mode. Signal Strength: Shows the wireless signal strength of the connection between the Micro Wireless N USB Adapter with the Access Point. Data Rate: Shows the statistics of data transfer, and the calculation is based on the number of packets transmitted and received. Configuration This screen is where you set the basic wireless settings for the Micro Wireless N USB Adapter. [. . . ] If a product does not operate as warranted during the applicable warranty period, TRENDnet shall reserve the right, at its expense, to repair or replace the defective product or part and deliver an equivalent product or part to the customer. The repair/replacement unit's warranty continues from the original date of purchase. All products that are replaced become the property of TRENDnet. TRENDnet shall not be responsible for any software, firmware, information, or memory data of customer contained in, stored on, or integrated with any products returned to TRENDnet pursuant to any warranty. [. . . ]