User manual TRANSTEL GROUP CPE-BM BATTERY MODULE FOR CPE ONE

[. . . ] Installation and Operation of the TransTel Battery Module for the CPE ONE Introduction The Battery Module (CPE-BM) houses two 2. 0 Ahr batteries and circuitry for charging the batteries. [. . . ] 770 368-8343 Fax 770 368-8382 10/96 and pull it out to a length of two to three inches. Orient the bottom of the CPE above the battery module as indicated in Figure 1. Hold the CPE ONE and the battery module tightly together and locate the four captive screws in the corners of the bottom side of the battery module. Using a blade screw driver, tighten by turning the captive screws clockwise. If desired, the wall mounting brackets can now be attached to the bottom plate of the battery module. To do this, one of the brackets must be mounted parallel to the above narrow face of the battery module shown in Figure 1. The other bracket must be mounted at the opposite bottom section. Figure 1. CPE ONE (top) in correct orientation above Battery Module for joining the two units. Note that the three flat-head screws of the CPE ONE (top part of drawing) and the three screws of the Battery Module (bottom part of drawing) line up on the same side. Operation of the CPE-BM Move the slide switch of the CPE ONE to ENABLE. [. . . ] If the two units do not fit together, repeat the above orientation procedure. Page 2 Page 3 [. . . ]