User manual TRANSCEND TS256MJFLASHA

[. . . ] These Windows operating systems have built-in drivers to support JetFlash. Simply plug JetFlash into an available USB port, and Windows will install the files needed to use your device. You will be able to find a new Removable Disk drive with a newly assigned drive letter in the My Computer window. Driver Installation for Mac OS 8. 6 or Later No driver is required. Just plug JetFlash into an available USB port and your computer will automatically detect it. Driver Installation for Linux Kernel 2. 4 or Later No driver is required. [. . . ] This option is able to choose and it can make JetFlash boot up as USB-ZIP mode. mFormat will copy boot up files into JetFlash and set up startup information during format. Make USB-HDD startup disk: (Only for Windows 98/98SE) When Disk 1 size is set to be larger than 2MB. This option is able to choose and it can make JetFlash boot up as USB-HDD mode. mFormat will copy boot up files into JetFlash and set up startup information during format. Enable password protection: Choose this option to set up password during format. If you format as two disks, the Disk 1 is public disk and Disk 2 will be password protected. 11 Create One Partition Slide the Disk-Volume bar all the way down to set Disk 1 size equal to the total capacity of JetFlash. JetFlash enable to set as USB-ZIP or USB-HDD boot up mode as below. Option 1 2 Configuration Make USB-ZIP startup disk Make USB-HDD startup disk BIOS USB-ZIP USB-HDD Option 1: Make USB-ZIP startup disk a. Select format type (Quick, Full or Configure device only) and Make USB-ZIP startup disk option. After the completion of format, you need to re-plug JetFlash to enable the setting. Restart your computer and press the Delete key (or whatever key combination is correct for your computer) during boot-up to enter Setup (CMOS Setup Utility) to reconfigure BIOS. Within the Advanced BIOS Features menu, change First Boot Device 12 to USB-ZIP. During boot-up, JetFlash will be assigned drive letter A (A : \ > appears on the screen). If your computer has a Floppy Drive, it will be assigned drive letter B. Please don't delete or move any of these files or boot-up function will fail. Select format type (Quick, Full or Configure device only) and Make USB-HDD startup disk option. Click Start to continue. b. After the completion of format, you need to re-plug JetFlash to enable the setting. Restart your computer and press the Delete key (or whatever key combination is correct for your computer) during boot-up to enter Setup (CMOS Setup Utility) to reconfigure BIOS. Within the Advanced BIOS Features menu, change First Boot Device to USB-HDD. [. . . ] Transcend reserves the right to provide a functionally equivalent refurbished replacement product. Limitations: This warranty does not apply to products that fail due to accident, abuse, mishandling, improper installation, alteration, acts of nature, improper usage, or problems with electrical power. Transcend JetFlash must be used with devices that conform to the recommended industry standards. Transcend will not be liable for damages resulting from a third party device that causes the Transcend product to fail. [. . . ]