User manual TRANSCEND TS128MJF-WL

[. . . ] These Windows operating systems have built-in drivers to support the Drivers will be required for the WLAN function (see Wireless LAN Two new Removable Disk drives with newly data portion of your JetFlash. Simply plug your JetFlash into an available USB port, and Windows will install the files needed to use it as an external hard drive. assigned drive letters will appear in the My Computer window. Warning To prevent loss of data and/or damage to your JetFlash, NEVER remove JetFlash from a device while the DATA LED is blinking. 4 Wireless LAN Function The WLAN Utility is JetFlash's management software. You must install the WLAN Utility found Before installing the WLAN Utility, verify that the switch is set to the "ON" position and carefully read the following steps. Install the WLAN Utility 1. Select the WLAN Utility button. 2. Select Next. 3. Select Yes. 5 4. Select Next. You can select Browse to choose the folder destination. [. . . ] Select the Enable option in the Power Saving Mode column. When the Power Saving Mode is enabled, JetFlash can work with low power consumption but the throughput may slow down. Select the icon in the system tray. 2. The Unplug or eject hardware pop-up menu will appear. Select to continue. 3. The Unplug or eject hardware window will appear. then select Stop to continue. Select USB Mass Storage Device and 22 4. The Safe To Remove Hardware window will appear. Select OK to continue. 5. Select WLAN miniUSB Adapter and select Stop to continue. 6. The Safe To Remove Hardware window will appear. Select the icon in the system tray. 2. The Safely Remove Hardware pop-up menu will appear. Select to continue. 3. The Safely Remove Hardware window will appear. Select USB Mass Storage Device and then select Stop to continue. 4. The Safe To Remove Hardware message balloon will appear. You may now safely unplug your JetFlash from your computer. 24 Uninstall WLAN Utility 1. Safely remove your JetFlash (see previous section). 2. Select the Panel. button on the Task Bar, go to Settings and then select Control 3. Double-click the Add or Remove Programs icon. 4. Select the IEEE802. 11b WLAN Utility and select Change or Remove Programs to continue. 25 5. Follow the InstallShield Wizard and select Remove to complete the un-installation. 6. Select Finish when the un-installation has completed. 26 Troubleshooting Q1: A1: Why doesn't the driver CD Auto-Run after it is inserted into the CD-ROM drive in Windows?This problem usually occurs because the Auto-Insert function of the CD-ROM drive is disabled. Please enter the Device Manager in Control Panel and enable the Auto-Insert function of the CD-ROM drive. Q2: A2: Why isn't my operating system detecting JetFlash after I've plugged it into the USB port of my computer?If not, refer the user's manual of your computer (or motherboard) to enable it. Follow the procedures below to verify if the Driver is installed properly. Right-click the My Computer icon on the desktop and the select Properties. WLAN miniUSB Adapter and then select Properties. Select the 27 c. If an error message appears in the Device Status window, select Remove. d. [. . . ] Transcend will not be liable for damages resulting from a third party device that causes the Transcend product to fail. Transcend shall in no event be liable for any consequential, indirect, or incidental damages, lost profits, lost business investments, lost goodwill, or interference with business relationships as a result of lost data. Transcend is also not responsible for damage or failure of any third party equipment, even if Transcend has been advised of the possibility. [. . . ]