User manual TOSHIBA SATELLITE 5000 FIELD REPLACEABLE UNIT DOCUMENTATION

[. . . ] Separate the battery pack from the battery cover. PC Card Eject button 1. Grasp the PC Card and pull it out NOTE: Before removing any PCMCIA device, make make it is "STOPPED" in the PC Card Manager. HDD REMOVAL HDD cover M2. 5x4 black flat head screw 1. Remove one M2. 5x4 black flat head screw securing HDD slot cover and pull out the cover. [. . . ] Disconnect the interface cable and the CD control/ touch pad cable from PJ124 and PJ114 on the system board. CD-R/W//DVD-ROM DRIVE REMOVAL CD-R/W/DVD-ROM connector CD-R/W/DVD-ROM drive SPEAKER(WOOFER) REMOVAL Speaker (woofer) M2x6 brass screws CD-R/W/DVD-ROM bracket M2x3 black screw CD-R/W/DVD-ROMside bracket woofer harness Glass tape PJ1106 2. Remove one M2x3 black screw securing the side bracket and lift out the bracket. Remove two M2x6 brass screws securing the CD-R/W/ DVD-ROM connector and the bracket. Lift out the speaker(woofer). Tough Enough for Today's World TOSHIBA FIELD REPLACEABLE UNIT DOCUMENTATION Satellite 5000 Series SOUND BOARD REMOVAL M2. 5x4 black flat head screws Hex screw Sound board Sound cable TM BATTERY BOARD REMOVAL M2x6 brass screws Plastic brace 1. Lift out the sound board and disconnect the sound cable (FMZFL1) from PJ1100 on the sound board. Battery harness 1. Remove two M2x6 brass screws securing the cpad cover and lift out the cover. Disconnect the two battery board harness from PJ1000 and 10001 on the battery board. Lift out the battery board assembly. RTC REMOVAL SECURE DIGITAL(SD) BOARD REMOVAL SD board RTC battery PJ752 RTC battery cable 1. Lift the RTC battery out of the slot. SD support plate M2x4 brass screw 1. Remove one M2x4 brass screw securing the SD support plate and the sound FIR board. Remove the SD support plate and lift up the back side of the sound/FIR board to disconnect it from PJ601 on the system board. Tough Enough for Today's World TOSHIBA FIELD REPLACEABLE UNIT DOCUMENTATION Satellite 5000 Series VIDEO BOARD REMOVAL COOLING MODULE REMOVAL TM M2x8 brass screws Hex screw Glass tape HDD con plate Video board 1. Remove one hex screw securing the HDD con plate and lift out the plate. Remove three M2x8 brass screws and securing the cooling module to the system board. Peel off the glass tape securing the DC harness and lift out the cooling module. CPU REMOVAL SYSTEM BOARD REMOVAL Sound cable Silicone grease PJ119 DC-IN harness PJ800 PJ820 2 CPU CPU lock 1 1. [. . . ] Carefully insert your fingers between the mask and the LCD panel and pry open the latches starting from the bottom six latches, to the five latches on the right and left sides, ending with the six toplatches. LCD/FL cable M2x5 silver screw FL inverter board 1. Carefully lift up the FL inverter board and disconnect the LCD/FL cable from CN1 and the FL cable from CN2. Remove four mask seals to expose four screws securing the LCD module assembly. [. . . ]