User manual TOSHIBA SATELLITE 2230 FIELD REPLACEABLE UNIT DOCUMENTATION

[. . . ] The following are registered trademarks of IBM Corporation: IBM, IBM PC AT, IBM PS/2. The following are registered trademarks of Microsoft Corporation: MS, MS-DOS, Windows 98. PCMCIA is a trademark of the Personal Computer Memory Card International Association. Phoenix and the Phoenix logo are registered trademarks of Phoenix Technologies, Ltd. [. . . ] Enables and disables the floppy disk drive controller for fixed floppy disk drive port. Enables and disables the integrated IDE controller. IDE controller Both; Disabled; Primary; Secondary. [Both] 64 LifeBook C Series from Fujitsu C o n f i g u r i n g Yo u r L i f e B o o k C S e r i e s Keyboard Features Submenu The Keyboard Features submenu is for setting the parameters of the integrated keyboard. Follow the instructions for Navigating Through the Setup Utility to make any changes. (See page 51. ) Table 4-5 shows the names of the menu fields for the Keyboard Feature submenu, the default settings and a description of the field's function and any special information needed to help understand the field's use. Main Advanced PhoenixBIOS Setup Utility Security Power Savings Exit Item Specific Help Keyboard Features Numlock: [Auto] Selects Power-on state for Numlock. F1 Help ESC Exit Select Item Select Menu -/Space Change Values Enter Select Sub-Menu v F9 Setup Defaults F10 Save and Exit Figure 4-5 Keyboard Features Submenu 65 Four Section Four Table 4-5 Fields, Options and Defaults of the Keyboard Submenu of the Advanced Menu Menu Field Options Default Description Numlock: Off; On; Auto. [Auto] Sets the NumLock function state when the computer completes booting. 66 LifeBook C Series from Fujitsu C o n f i g u r i n g Yo u r L i f e B o o k C S e r i e s Multimedia Device Configuration Submenu The Multimedia Device Configuration submenu is for setting the features of the built-in audio functions. Follow the instructions for Navigating Through the Setup Utility to make any changes. (See page 51. ) Table 4-6 shows the names of the menu fields for the Multimedia Device Configuration submenu, all of the options for each field, the default settings and a description of the field's function and any special information needed to help understand the field's use. Main Advanced PhoenixBIOS Setup Utility Security Power Savings Exit Item Specific Help Multimedia Device Configuration [Enabled] User configuration [Auto] BIOS or OS chooses configuration POINT All I/O addresses in Table 4-6 are in hexadecimal. F1 Help ESC Exit Select Item Select Menu -/Space Change Values Enter Select Sub-Menu v F9 Setup Defaults F10 Save and Exit Figure 4-6 Multimedia Device Configuration Submenu 67 Four Sound: Base I/O address: WSS I/O address: FM I/O address: Interrupt: 1st DMA channel: 2nd DMA channel: [Enabled] [220-22Fh] [530h-53Fh] [388h-38Bh] [IRQ 5] [DMA 1] [DMA 0] Configure sound device using options: [Disabled] No configuration Section Four Table 4-6 Fields, Options and Defaults of the Multimedia Device Configuration Submenu of the Advanced Menu Menu Field Options Default Description Sound: Disabled; Enabled; Auto. When set to Auto, the BIOS or OS will choose the proper sound configuration settings and some of the following items will not appear. Base I/O address: WSS-I/O address: FM I/O address: Interrupt: 1st DMA channel: 2nd DMA channel: 220-22Fh; 240-24Fh; 260-26Fh; 280-28Fh. [220-22Fh] [530h-53Fh] [388h-38Bh] [IRQ 5] [DMA 1] [DMA 0] When Sound is Enabled, this option is available allowing the user to set the base I/O address for the sound device. When Sound is Enabled, this option is available allowing the user to set the I/O address for the WSS. To cancel a password press the Enter key instead of entering characters in the Enter New Password field and in the Re-enter New Password field. When a Supervisor Password is set it must be used to access the BIOS setup utility. (This field can only be accessed if the Supervisor Password is set. ) Sets, changes or cancels the User Password. The User Password may be up to eight characters long and must include only lower case letters or numbers. To cancel a password press the Enter key instead of entering characters in the Enter New Password field and in the Re-enter New Password field. When a User Password is set it must be used to access the BIOS setup utility. Set User Password: [Enter] -- 73 Four Section Four Table 4-8 Fields, Options and Defaults for the Security Menu Menu Field Diskette access: Options All; Supervisor Only. Description Sets the floppy disk access to be secured for access only with Supervisor's password or by all users with a password. When set to Enabled, a password (User or Supervisor) is required after the Power On Self Test (POST) before the operating system will be read from a disk. If no Supervisor Password is set this feature is not available and no password is required. When set to Enabled, a password, is required upon Resume from Suspend or Save-to-Disk Mode. Sets write protection for the sector of the boot disk which contains the operating system. [. . . ] A program which is part of the BIOS which checks the configuration and operating condition of your hardware whenever power is applied to your Computer. Status and error messages may be displayed before the operating system is loaded. If the self test detects failures that are so serious that operation can not continue, the operating system will not be loaded. Program An integrated set of coded commands to your computers telling your hardware what to do and how and when to do it. [. . . ]