User manual TOSHIBA MIRAI RAS-13BKVG-E

[. . . ] — Do not use this air conditioner for other purposes such as preserving food, breeding animal, etc. — Before cleaning the unit, turn off the main switch or the circuit breaker. — When the unit won’t be used for a long time, turn off the main switch or the circuit breaker. — It is recommended that maintenance be performed by a specialist when the unit has been operated for a long time. [. . . ] Three-minute protection feature: To prevent the unit from being activated for 3 minutes when suddenly restarted or switched to ON. Preheating operation: Warm up the unit for 5 minutes before the heating operation starts. Warm air control: When the room temperature reaches the set temperature, the fan speed is automatically reduced and the outdoor unit will stop. Heating capacity: Heat is absorbed from outdoors and released into the room. When the outdoor temperature is too low, use another recommended heating apparatus in combination with the air conditioner. Consideration for accumulated snow: Select the position for outdoor unit where it will not be subjected to snow drifts, accumulation of leaves or other seasonal debris. This is normal because the cracking sound may be caused by expansion/ contraction of plastic. Note: Item 2 to 6 for Heating model Air conditioner operating conditions Temp. Outdoor Temperature 50% 11 DISPLAY LAMP BRIGHTNESS ADJUSTMENT To decrease the display lamp brightness or turn it off. Press and hold for 3 seconds until brightness level ( , , or ) is shown on remote control LCD then release the button. Room Temperature Less than 28°C 21°C ~ 32°C 17°C ~ 32°C Lamp illuminates 50% brightness. 50% Lamp illuminates 50% brightness and the operation lamp is turned off. Operation Heating Cooling Dry –15°C ~ 24°C –15°C ~ 46°C –15°C ~ 46°C All turned off All lamps are turned off. And , the lamp illuminates for 5 seconds before 12 TEMPORARY OPERATION In case of the misplaced or discharged remote control ● Pressing the RESET button, the unit can start or stop without using the remote control. ● Operation mode is set on AUTOMATIC operation , preset temperature is 24°C and fan operation is automatic speed. 13 AUTO RESTART OPERATION To automatically restart the air conditioner after the power failure (Power of the unit must be on. ) 18 REMOTE CONTROL A-B SELECTION To separate using of remote control for each indoor unit in case of 2 air conditioner are installed nearly. Press and hold the RESET button on the indoor unit for 3 seconds to set the operation. Press and hold the RESET button on the indoor unit for 3 seconds to cancel the operation. (3 beep sound but OPERATION lamp does not blink) • In case of ON timer or OFF timer are set, AUTO RESTART OPERATION does not activate. €B” will show on the display and “00” will disappear and the air conditioner will turn OFF. SELF CLEANING OPERATION 14 (COOL AND DRY OPERATION ONLY) To protect bad smell caused by the humidity in the indoor unit. [. . . ] 1 2 Information according to EMC Directive 2004/108/EC (Name of the manufacturer) (Address, city, country) (Name of the Importer/Distributor in EU) (Address, city, country) TOSHIBA CARRIER (THAILAND) CO. Tryk på RESET-knappen på den indendørs enhed for at TÆNDE for klimaanlægget. 1 2 Information according to EMC Directive 2004/108/EC (Name of the manufacturer) (Address, city, country) (Name of the Importer/Distributor in EU) (Address, city, country) TOSHIBA CARRIER (THAILAND) CO. 1 2 Information according to EMC Directive 2004/108/EC (Name of the manufacturer) (Address, city, country) (Name of the Importer/Distributor in EU) (Address, city, country) TOSHIBA CARRIER (THAILAND) CO. [. . . ]