User manual TOSHIBA MAGNIA Z500

[. . . ] Indication Meaning of Indication Text set off in this manner indicates that failure to adhere to the directions in the warning could result in serious bodily harm (*1) or loss of life if the product is handled improperly. Text set off in this manner indicates that failure to adhere to the directions in the caution could result in serious bodily injury (*2) or damage (*3) to property if the product is handled improperly. *1: Serious bodily harm indicates loss of eyesight, injury, burns, electric shock, bone fracture, poisoning, and other injuries which leave aftereffect and require hospitalization or long-term treatment as an outpatient. [. . . ] *2: Bodily injury indicates injury, burns, electric shock, and other injuries which do not require hospitalization or longterm treatment as an outpatient. The actual contents of the prohibition are indicated by a picture or text placed inside or next to the graphic symbol. The actual contents of the obligation indicated by a picture or text placed inside or next to the graphic symbol. Ask an authorized dealer or qualified installation professional to install or reinstall this unit. Electrical work must be performed by a qualified electrician in accordance with this installation manual. The work must satisfy all local, national and international regulations. Be sure to turn off all main power supply switches before starting any electrical work. The Energy Monitoring Relay Interface is used to measure and distribute the power of the air conditioner. Set SW7 as "120 ohm" on a Energy Monitoring Relay Interface with address SW1=1, when the Energy Monitoring Relay Interface is used in a system without TCS-NET Relay Interface. Address independently from the TCS-NET Relay Interface address or the Digital Input/ Output Relay Interface address. Address set switch 1-8 0, 9-F Address Not used The following settings are necessary to use Energy Monitoring Relay Interfaces. ⷠSW1 Address set switch When two or more Energy Monitoring Relay Interfaces are used, set a different address for each unit to avoid address duplication. You can set the Energy Monitoring Relay Interface address independently from the TCS-NET Relay Interface address or the Digital Input/Output Relay Interface address. Operation mode set switch These switches are not used during normal operation. Test switch Reset switch When performing an address setting with SW1, push this reset switch after the address setting to read the set value. rS-485 terminator resistor select switch · Set an RS-485 terminator resistor on a TCS-NET Relay Interface, when an Energy Monitoring Relay Interface is used with the TCS-NET Relay Interface in the same system. [. . . ] rS-485 terminator resistor select switch · Set an RS-485 terminator resistor on a TCS-NET Relay Interface, when an Energy Monitoring Relay Interface is used with the TCS-NET Relay Interface in the same system. Set SW7 as "120 ohm" on an Energy Monitoring Relay Interface with address SW1=1, when the Energy Monitoring Relay Interface is used in a system without TCS-NET Relay Interface. When a Digital Input/Output Relay Interface is used with these interfaces in the same system, terminator resistor setting on the Digital Input/Output Relay Interface is not necessary. [. . . ]