User manual TOSHIBA L10

[. . . ] TOSHIBA L10 Series User's Manual TOSHIBA L10 Series Copyright © 2004 by TOSHIBA Corporation. Under the copyright laws, this manual cannot be reproduced in any form without the prior written permission of TOSHIBA. No patent liability is assumed, with respect to the use of the information contained herein. TOSHIBA L10 Series Portable Personal Computer User's Manual First edition December 2004 Ownership and copyright of music, video, computer programs, databases, etc. [. . . ] To view details of the Volume Control, click Help on the Volume Control. Microphone level The change the microphone gain, follow the steps below. Click start, point to All Programs, point to Accessories, point to Entertainment and click Volume Control. Check the Microphone Boost checkbox. Modem This section describes how to connect and disconnect the internal modem to and from a telephone jack. In case of a lightning storm, unplug the modem cable from the telephone jack. A digital line will damage the modem. User's Manual 4-20 Operating Basics Region selection Telecommunication regulations vary from one region to another, so you will need to make sure the internal modem's settings are correct for the region in which it will be used. Click start, point to All Programs, TOSHIBA, Networking, and click Modem Region Select. Do not use the Country/Region Select function in the Modem setup utility in the Control Panel if the function is available. If you change the Country/ Region in the Control Panel, the change may not take effect. Click the icon with the primary mouse button to display a list of regions that the modem supports. A check will appear next to the currently selected region and telephony location. Select a region from the region menu or a telephony location from the sub-menu. When you click a region it becomes the modem's region selection, and the New Location for telephony will be set automatically. When you select a telephony location, the corresponding region is automatically selected and it becomes the modem's current region setting. Properties menu Click the icon with the secondary mouse button to display properties menu on the screen. Settings You can enable or disable the following settings: AutoRun Mode The Region Select utility starts automatically when you start up the operating system. Open the Dialing Properties dialog box after selecting region. The dialing properties dialog box will be displayed automatically after you select the region. Location list for region selection. A submenu appears displaying location information for telephony. User's Manual 4-21 Operating Basics Open dialog box, if the modem and Telephony Current Location region code do not match. A warning dialog box is displayed if current settings for region code and telephony location are incorrect. Modem Selection If the computer cannot recognize the internal modem, a dialog box is displayed. Select the COM port for your modem to use. Dialing Properties Select this item to display the dialing properties. If you are using the computer in Japan, the Telecommunications Business Law requires that you select Japan region mode. It is illegal to use the modem in Japan with any other selection. Connecting To connect the modem cable, follow the steps below. The modular cable that comes with the computer must be used to connect a modem. In case of a lightning storm, unplug the modem cable from the telephone jack. Plug the other end of the modular cable into a telephone jack. Connecting the internal modem Do not pull on the cable or move the computer while the cable is connected. If you use a storage device such as an optical drive or hard disk drive connected to a 16-bit PC Card, you might experience the following modem problems: Modem speed is slow or communication is interrupted. Skips may occur in sound. User's Manual 4-22 Operating Basics Disconnecting To disconnect the internal modem cable, follow the steps below. Pinch the lever on the connector in the telephone jack and pull out the connector. [. . . ] TOSHIBA portable computers comply with Class B computing device regulations. Random Access Memory (RAM): High speed memory within the computer circuitry that can be read or written to. restart: Resetting a computer without turning it off (also called "warm boot" or "soft reset"). A device that uses three input signals, each activating an electron gun for a primary additive color (red, green, and blue) or port for using such a device. [. . . ]