User manual TOSHIBA GIGAFRAME L80/81

[. . . ] Pull over in a safe and legal manner before attempting to access a function of the system requiring prolonged attention. Even occasional short scans to the screen may be hazardous if your attention has been diverted away from your driving task at a critical time. Keep the volume at a level where you can still hear outside traffic and emergency signals while driving. Driving while unable to hear these sounds could cause an accident. For your Health! When using ear buds or other headphones, be careful not to listen at excessive volume. [. . . ] -The surface temperature of the AC adapter may increase while the power is on, but this does not mean the adapter is faulty. Before carrying, unplug the AC cable and wait until the AC adapter cools. -Buzzing noises may occasionally be heard from the inside of the AC adapter, but this is not abnormal. -Using the AC adapter near a radio, television or cellular phone may cause radio interference, so use the adapter at a sufficient distance from such appliances/devices. When using the product overseas, provide a separate AC cable conforming to the local standard. 17 Parts diagram a i b a b Headphone /V-OUT jack Lock switch Slide this switch in the direction of the arrow to lock the gigabeat to prevent inadvertent button operations. POWER button SKIP button PLAY/PAUSE button SKIP button c c d j e f k n g l m + d VOL(+)/VOL(-) button e f g VOL. h AC adapter jack i Strap attachment hole j Display screen (Color screen) k l BACK button START button h m Plus Touch button op q n OK button (referred to as "ok" in this manual) o BATTERY switch Comes from the factory in the "off" position. When not using the gigabeat for extended periods, switch this to "off" and it will extend the life of your battery. Note -Use only Toshiba authorized accessories when connecting to the pin connector at the bottom of the unit. 18 Setting Up the gigabeat Set Up Charging the Built-in Battery When charging the gigabeat for the first time, make certain to fully charge the battery. Preparation Set the BATTERY switch on the bottom of the main unit to ON. Using the AC Adapter Connect the AC adapter to the gigabeat in the order A to C shown below. It takes approximately 3 hours to fully charge the gigabeat. C Connect to outlet B A Battery icon display Battery Status Charging Fully charged Charging completed 19 Charging via the USB Cable Connect the gigabeat to the PC via the supplied USB cable. / Note -If Windows Media® Player 10 is not installed on your PC, the gigabeat cannot be connected properly. Install Windows Media Player 10 before you connect the gigabeat to your PC. (>p. 22) To the USB terminal on the PC Battery icon display Battery Status Charging Fully charged Charging completed -Battery power may be used when the gigabeat is operating such as transferring tracks even if it is connected via USB. Note -If the battery is low when you connect the gigabeat to your PC, you should also plug in the AC adapter otherwise some of the data being transferred could be lost. -While transferring data to the gigabeat, never disconnect the USB cable or AC Adapter. If the screen displays "Updating", do not disconnect the gigabeat. Do not disconnect the USB cable if "Connected" is not displayed on the screen. -While the gigabeat is connected to the PC you will not be able to operate it. -Operation cannot be guaranteed when the gigabeat has been connected to a PC using a USB hub. 24 Setting Up the gigabeat Basic Operation Basic Operation Buttons on the gigabeat and their Functions Back button Returns you to the previous screen. Plus Touch button Touch the top, bottom, left or right to select a menu item. START button Displays the Start screen in which you can select a menu item to operate. OK button Confirms the item selection made with the Plus TouchTM button and performs the associated function. Start screen The Start screen is the basic screen for all gigabeat operations. Selection of any menu items starts from this screen. 25 Selecting an item Touch the top or bottom of the Plus Touch button to move between the selection items. Touch the left or right of the Plus Touch button to change the items. Confirming your selection Press the OK to perform the function of the selected item. 26 On-screen Displays Icons Track name Track Number Elapsed Time bar Artist name Album title Random play Battery Power Charging Charging completed Battery Power This will flash if the battery life drops to zero. elapsed time and remaining time Each time you press OK, it switches the elapsed and remaining time display. (>p. 36) Repeat play (>p. 36) Play Pause Rewind Forward Lock Standby screen This screen is displayed when the gigabeat is transferring information. You cannot operate the gigabeat while this screen is displayed. This screen is also displayed when a display takes a long time to appear such as with large photo files. 27 Enjoying Music Downloading Tracks Downloading Tracks from a Music CD to Your PC a Insert the music CD in the CD-ROM drive of your PC. [. . . ] The PC does not recognize the gigabeat. Cause The charge is automatically stopped to limit the temperature increase in the gigabeat. The gigabeat is not properly connected to the PC. Solution Refer This is a safety feature. 24 Reset If the issue cannot be resolved after taking the above corrective actions, reset the main unit by following the steps below: 1 Unplug the AC adapter from the main unit. After about 5 seconds, turn the battery switch "ON" again. Settings won't return to the initial state. [. . . ]