User manual TOSHIBA CN32C90

[. . . ] This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. [. . . ] The audio output is muted during SPEED SEARCH, STILL, If the still picture jitters excessively, press TRK + / to FRAME ADVANCE and SLOW MOTION. stabilize the still picture. Slow motion During playback press SLOW. To return to playback, press PLAY or SLOW. During picture search mode there will be noise bars which are caused by the system. The Special Playback will automatically change to playback after approx. 5 minutes to protect the video tape against excessive wear. Slow tracking and vertical lock adjustment If noise bars appear in the picture during slow motion, press the TRK + / to reduce the noise bars. Frame by frame picture Press PAUSE/STILL during playback. To return to playback, press PLAY or PAUSE/STILL. CM skip Press CM SKIP during playback. The unit will search forward through approximately 30 seconds of the tape (e. g. unwanted commercial time) for each press of CM SKIP (maximum six presses) and then resume normal playback. For example : 1 press: 30 seconds of tape 2 press: 60 seconds of tape 3 press: 90 seconds of tape 35 5L00201C [E]p33-37 35 20/4/04, 16:07 Playback (VCR) Convenient function MENU DISPLAY REC PLAY COUNTER RESET Repeat playback Using the real time tape counter The entire video tape will be played until its end. The tape The on-screen real time tape counter shows the tape will automatically rewind to the beginning and the playback running time in hours, minutes and seconds. You can easily determine how long the tape has been running or will be repeated. TV - VHF/UHF channels CABLE - Cable TV channels Press Direct channel selection (09) or CHANNEL / to select the channel to be recorded. 2 5 8 0 3 CH 110 To cancel OTR Press STOP. STOP " CHANNEL " will appear on screen for about 4 seconds. 6 9 Notes: If you wish to watch the DVD playback during the recording or the OTR, press the DVD button to change to DVD mode and perform the DVD playback 44 . The channel cannot be changed during recording. 39 5L00201C [E]p38-41 39 20/4/04, 16:07 Recording (VCR) Timer recording Timer recording can be programmed on-screen with the remote control. The built-in timer allows automatic unattended recording of up to 8 programs within 1 month. TV/VCR TIMER REC MENU ENTER Timer recording Preparation: Press TV/VCR to select the TV/VCR mode. Example: Program a timer recording for 23rd day, channel 125 (Cable TV), 7:00 - 9:30 PM (Tape speed : SLP). 5 Set the start time, end time, channel and tape speed as in step 4. Then press ENTER. TIMER REC SET DATE START 2 3(THU) 7:0 0PM 9:3 0PM 125 SLP / ENTER/MENU ENTER END CH SPEED / / / 1 2 Press MENU, then press option. or to select Notes: Press to move cursor backward for correction. To record from external source set the channel to "L1" or "L2". 23 TH 7:00PM 9:30PM 125 SLP MENU TIMER REC SET AUTO REPEAT ENTER OFF SETUP / / / / MENU / / ENTER/CANCEL/MENU Press press or . to select "TIMER REC SET", then TIMER AUTO REC SET OFF REPEAT ENTER 6 7 To set the timer for another program, repeat steps 3 to 5 to set another program. The Timer is programed, when the programed time is reached, the recording is automatically started. TIMER REC / / / MENU TIMER REC 3 4 Press or to select one of the program line, then press ENTER. To cancel timer recording, press both the buttons again and TIMER REC indicator will go out. ENTER Press or to select the date, then press . TIMER REC SET DATE 2 3(THU) 8:3 0AM : 012 SP / MENU START END CH SPEED / / / ENTER Notes: The VCR section cannot be used while the TIMER REC indicator is lit. If you want to use the VCR operation, press both TIMER REC buttons at the same time to deactivate the timer. After a power failure or disconnection of the power plug, all programmed recording setting and time display will be lost upon resumption of power. In this case, reset the clock (see pages 19~21) and reprogram any timer recordings. If you want to correct the digits while setting, press or until the item you want to correct, then press or to correct the desired setting. [. . . ] . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]