User manual TOSHIBA B-852-TS12-QQ

[. . . ] TEC Label/Tag Printer B-852-TS12-QQ Owner's Manual This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operations of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. [. . . ] Most Windows applications are unable to access these bar codes directly. However, it is possible to create an artificial font that represents a bar code, and then this font will be listed and can be selected within any Windows application that supports printer fonts. At print time, the font is converted by the driver into the desired bar code. · Some symbologies will have minimum and maximum data lengths, or only accept certain characters. The bar font functionality in this driver will properly filter, format and add necessary characters to bar codes before they are printed. This Property Page will allow adding, deleting, modifying, importing, exporting, and viewing currently defined bar code fonts. These fonts will be listed in many Windows applications that normally do not support printing bar codes. Although they will not appear as bar codes on the screen, they will print as bar codes. An unlimited number of bar fonts can be created, each of which may have different bar code parameters. Upon pressing the Bar Fonts tab the screen display below will appear. 3-21 3. PRINTER OPERATION EO1-33029 3. 4 Using the B-852 Printer Properties Menus 3. 4. 7 Bar Fonts Tab (Cont. ) The above window has the following functions: · Bar Fonts View List. This window will display a list of all bar code fonts currently set up and their resolution they were created at in dots per inch (dpi). The status bar at the bottom of this list will display information about the currently selected font. If a font in the view window is selected, the new bar code font settings will be copied from the currently selected bar code font. Allows importing a list of bar code fonts that have previously been exported. · · · · · Export button. This file can be loaded into the driver on a different host computer, and even a different operating system. Checking this box limits the view of bar code fonts to only those supported by the current printer. · Whenever the New button or the Edit button is pressed, the following screen display will appear: Options on the Edit Bar Code Font property page above, will allow specifying exactly how the printed bar code should appear on the document or label. 3-22 3. PRINTER OPERATION EO1-33029 3. 4 Using the B-852 Printer Properties Menus 3. 4. 7 Bar Fonts Tab (Cont. ) Bar Code Options: · Symbology. Used to specify bar code density using the narrow bar "X-dimension. " (Used with all symbologies except US Postnet. ) · Bar Code Orientation. Used to change the vertical or horizontal orientation of an object on the label. Used to specify the position and visibility of the human readable characters displayed with the bar codes on the labels. (Used with Full ASCII 3-of-9, Regular 3-of-9, Codabar, Interleaved 2-of-5, and MSI Plessey only. ) Symbology Specific Options: · Check Digit. Used to specify whether or not check digits will be added to bar codes. [. . . ] or less, it is rounded down and no data is added to the memory at power off. When a sent command results in an error, the same number as the data capacity of the command is counted by byte. If the media distance covered is 69. 4 cm or less, it is rounded down and no data is added to the memory at power off. When the media distance covered reached to the maximum, the maintenance counter should be cleared. [. . . ]