User manual TOSHIBA 15DLV75

[. . . ] Introduction 2 15-inch Diagonal LCD TV/DVD COMBINATION * Connections 14 Basic setup 21 TV operation 23 15DLV76 OWNER'S MANUAL Basic playback 31 Advanced playback 34 Function setup 46 Others 53 ©2006 Toshiba Corporation Before operating the unit, please read this manual thoroughly. *Screen size is approximate. J5X00221A [E] (Cover) 1 21/02/2006, 8:36 PM Introduction The lightning flash with arrowhead symbol, within an equilateral triangle is intended to alert the user to the presence of uninsulated dangerous voltage within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. WARNING: CAUTION : TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. [. . . ] Now your settings were set into the memory. PICTURE V-CHIP V-CHIP TV RATING MOVIE RATING NEW PASSWORD :SELECT :ADJUST ON/OFF TV-Y PG-13 AUDIO SETUP V-CHIP 3 Press or to select "MOVIE RATING". 7 Press CANCEL to clear the menu screen. CANCEL PICTURE V- C H I P V- C H I P T V R AT I N G AUDIO SETUP V- C H I P OFF T V- Y OFF M O V I E R AT I N G OFF/G/PG/PG-13/R/NC-17/X N E W PA S S W O R D :SELECT :ADJUST To use after the TV is protected When you try to view a program with a ratings block, a message will appear listing the program's ratings. The program can still be viewed if you press MUTE and then enter your password to temporarily bypass the block. Note: The V-Chip function is activated only on programs that have the rating signal. 27 J5X00221A [E] (P26-30) 27 21/02/2006, 8:40 PM TV operation Picture control adjustment/ Adjusting the picture mode Picture controls are factory preset but you can adjust them individually as follows: And also you can select four picture modes--Standard, Sports, Movie, and Memory--as described in the following table: CANCEL /// MENU Picture control adjustment Adjusting the picture mode to select 1 2 Press MENU and then press "PICTURE". PICTURE PICTURE MODE or AUDIO SETUP V-CHIP 1 Press MENU and then press "PICTURE". PICTURE or to select AUDIO SETUP V- C H I P SPORTS 25 50 25 00 25 :ADJUST PICTURE MODE BRIGHTNESS CONTRAST COLOR TINT SHARPNESS :SELECT S P O RT S 25 50 25 00 25 :ADJUST BRIGHTNESS CONTRAST COLOR TINT SHARPNESS :SELECT Press or to select the item you want to or to adjust the setting. adjust, then press PICTURE PICTURE MODE BRIGHTNESS CONTRAST COLOR TINT SHARPNESS :SELECT SPORTS 25 50 25 00 25 :ADJUST AUDIO SETUP V-CHIP 2 Press or or to select "MODE", then press to select the desired picture mode. PICTURE PICTURE AUDIO SETUP V-CHIP SPORTS MODE SPORTS/STANDARD/MOVIE/MEMORY 25 BRIGHTNESS 50 CONTRAST 25 COLOR 00 TINT 25 SHARPNESS :SELECT :ADJUST Selection BRIGHTNESS CONTRAST COLOR TINT SHARPNESS Pressing darker lower paler reddish softer lighter higher deeper greenish sharper Mode SPORTS STANDARD MOVIE MEMORY Picture quality Bright and dynamic picture (factory-set) Standard picture quality (factory-set) Movie-like picture setting (factory-set) Your personal preferences (set by you; see "Picture control adjustment" as left) Note: The CONTRAST default setting is set to maximum (+50) at the factory. 3 Press CANCEL to clear the menu screen. CANCEL 3 Press CANCEL to clear the menu screen. CANCEL I To return all adjustments to the factory preset levels Press or to select "RESET", then press . Note: You cannot select "MODE" in the Game mode. 28 J5X00221A [E] (P26-30) 28 21/02/2006, 8:40 PM Selecting the color temperature CANCEL /// MENU Selecting the color temperature 1 Press MENU and then press "PICTURE" PICTURE PICTURE or to select AUDIO SETUP V-CHIP TV operation MODE BRIGHTNESS CONTRAST COLOR TINT SHARPNESS :SELECT SPORTS 25 50 25 0 25 :ADJUST 2 Press or to select "COLOR TEMPERATURE". PICTURE PICTURE AUDIO SETUP V-CHIP COLOR TEMPERATURE RESET COOL COOL/MEDIUM/WARM :SELECT :ADJUST 3 Press mode. or to select the desired color PICTURE PICTURE AUDIO SETUP V-CHIP COLOR TEMPERATURE RESET WARM COOL/MEDIUM/WARM :SELECT :ADJUST Mode COOL MEDIUM WARM Picture quality Bluish Neutral Reddish 4 Press CANCEL to clear the menu screen. CANCEL Note: You cannot select "COLOR TEMPERATURE" in the Game mode. 29 J5X00221A [E] (P26-30) 29 21/02/2006, 8:41 PM TV operation Sound control adjustment/ Stereo and Second Audio Program (SAP) Sound controls are factory preset but you can adjust them individually as follows: The TV/DVD is equipped with a feature known as multi-channel TV sound or MTS. MTS broadcasts greatly enhance TV viewing by bringing you programs with high fidelity stereo sound. MTS also provides an extra channel called the Second Audio Program or SAP which broadcasters can use to transmit a second language for bilingual transmission or for other purposes. CANCEL /// MENU Sound control adjustment Listening to stereo sound to select Repeat step 1 in "Sound control adjustment" on or to select "MTS". Then press When the TV is turned on or a channel selection is made, the "STEREO" will appear on the screen. · When mono broadcasting is received, no indication is displayed. · If the broadcast signal is not strong enough or clear stereo sound is not available, select "MONO". The noise may be eliminated. 1 2 Press MENU and then press "AUDIO" PICTURE AUDIO MTS BASS TREBLE BALANCE SURROUND RESET or AUDIO SETUP V-CHIP STEREO 25 25 00 OFF :SELECT :ADJUST Press or to select the item you want to or to adjust the setting. adjust, then press PICTURE AUDIO MTS BASS TREBLE BALANCE SURROUND RESET STEREO 25 25 00 OFF AUDIO SETUP V- C H I P :SELECT :ADJUST STEREO MTS Press or to select "STR" (STEREO), "SAP" or "MONO". ON: The dynamic presence and sound created offers a thoroughly enjoyable listening experience. OFF: Normal sound. Listening to SAP (Second Audio Program) Repeat step 1 in "Sound control adjustment" on or to select "MTS". Then press When the TV is turned on or a channel selection is made, the "SAP" will appear on the screen. This means that the Second Audio Program broadcasting is available. 3 Press CANCEL to clear the menu screen. CANCEL STEREO SAP I To return BASS/TREBLE/BALANCE control adjustments to the factory preset levels or to select "RESET", then press . Press 30 J5X00221A [E] (P26-30) 30 21/02/2006, 8:41 PM Basic playback Playing a disc This section shows you the basics on how to play a disc. CAUTION Keep your fingers well clear of the disc slot when disc is loading or unloading. Neglecting to do so may cause serious personal injury. DVD VCD CD POWER VOLUME +/­ PLAY STOP EJECT Basic playback Preparations: · When connecting to other equipment, turn the power off. 1 Press POWER on the unit or on the remote control to turn on the unit. · When using an amplifier, switch on the amplifier. 4 On the TV-screen, "0" changes to "Reading" and then playback commences. Reading Basic playback 2 Press TV/DVD on the remote control to select DVD mode. The DVD startup screen will appear on the screen. · A menu screen will appear on the TV screen if the disc has a menu feature. Title is selected and play commences. 5 3 Load a disc in the disc slot. Press VOLUME + or ­ to adjust the volume. VOLUME 32 6 Load the disc in the disc slot with the label side facing forward. (If the disc has a label. ) Hold the disc without touching either of its surfaces, align it with the guides, and place it in position. Press STOP to end playback. I Resuming facility · The unit records the stopped point, depending on the disc. [. . . ] DURING THIS PERIOD, TACP WILL, AT TACP'S OPTION, REPAIR OR REPLACE A DEFECTIVE PART WITH A NEW OR REFURBISHED PART WITHOUT CHARGE TO YOU. Rental Units The warranty for LCD TV/DVD Combination rental units begins on the date of the first rental or thirty (30) days after the date of shipment to the rental firm, whichever comes first. Commercial Units LCD TV/DVD Combinations sold and used for commercial purposes have a limited warranty for all parts and labor, which warranty begins on the date of original retail purchase and ends on the date that is ninety (90) days thereafter. Owner's Manual and Product Registration Card Read this owner's manual thoroughly before operating this LCD TV/DVD Combination. [. . . ]