User manual TORO 20041

[. . . ] The enclosed Engine Owner's Manual is supplied for information regarding The U. S. Environmental Protection Agency (EPA) and the California Emission Control Regulation of emission systems, maintenance and warranty. Replacements may be ordered through the engine manufacturer. Safety This lawn mower meets or exceeds the CPSC blade safety requirements for walk-behind rotary lawn mowers and the B71. 1 specifications of the American National Standards Institute in effect at the time of production. Read and understand the contents of this manual before the engine is ever started. [. . . ] Slowly pour oil into the oil fill tube to raise the oil level to the Full mark on the dipstick. Important: Change the engine oil after the first 2 operating hours; change it yearly thereafter. Rotate the handle rearward (as shown) until it clicks into place. m-5650 3328-280 5 Before Operating Danger Gasoline is extremely flammable and explosive. A fire or explosion from gasoline can burn you and others. S S S S To prevent a static charge from igniting the gasoline, place the container and/or mower directly on the ground before filling, not in a vehicle or on an object. Do not handle gasoline when smoking or around an open flame or sparks. Store gasoline in an approved fuel container, out of the reach of children. Warning Adjusting the cutting height may bring you into contact with the moving blade, causing serious injury. S S Stop the engine and wait for all moving parts to stop. Do not put your fingers under the housing when adjusting the cutting height. Filling the Fuel Tank Fill the fuel tank with fresh unleaded regular gasoline from a major name-brand service station. Important: To reduce starting problems next season, add fuel stabilizer to the fuel all season, mixing it with gasoline less than 30 days old. 1/2 in. Remove the dipstick, wipe it clean, and fully install the dipstick. m-5571 m-5653 m-5570 m-5653 2. If the oil level is below the Add mark on the dipstick, slowly pour oil into the oil fill tube to raise the oil level to the Full mark on the dipstick. fill: 20 oz. , type: SAE 30 detergent oil with an API service classification of SF, SG, SH, or SJ. ) 3. After performing the maintenance procedure(s), connect the spark plug wire to the spark plug. Note: Before tipping the mower to change the oil or replace the blade, allow the fuel tank to run dry through normal usage. If you must tip the mower prior to running out of fuel, use a hand fuel pump to remove the fuel. Always tip the mower onto the right side. m-5594 Warning Tipping the mower may cause the fuel to leak. Run the engine dry or remove the gasoline with a hand pump; never siphon. 3328-280 10 Changing the Engine Oil Change the engine oil after the first 2 operating hours; change it yearly thereafter. Remove the dipstick. Replacing the Blade Important: You will need a torque wrench to install the blade properly. If you do not have a torque wrench or are uncomfortable performing this procedure, contact an Authorized Service Dealer. If the blade edge is dull or nicked, have it sharpened or replace it. Warning m-5604 2. Tip the mower onto the right side to drain the used oil out through the oil fill tube. The blade is sharp; contacting the blade can result in serious personal injury. Wear cloth or leather gloves when servicing the blade. Warning m-5590 3. Slowly pour oil into the oil fill tube until the oil level reaches the Full line on the dipstick. [. . . ] (30 ml) of oil through the spark plug hole, and pull the starter rope slowly several times to distribute oil throughout the cylinder to prevent cylinder corrosion during the off-season. Important: Route the cables to the outside of the handle knobs as you fold the upper handle. 3. To unfold the handle, reverse the steps above. Removing from Storage 1. Remove the spark plug and spin the engine rapidly using the starter to blow the excess oil from the cylinder. [. . . ]