User manual TORNADO TO4412

[. . . ] 25 Cleaning and care Frequently asked questions Optional accessories Technical Service Caring for the environment 3 IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE WARNINGTo reduce the risk of fire, electric shock or injury: ~ To reduce the risk of electric shock, Before using ~ Check the voltage rating of the vacuum cleaner before connecting the power cord to an electrical outlet. Your power source should correspond with the voltage rating plate located on the underside of the vacuum. If you are not sure of your home's voltage supply, consult a qualified electrician. Connecting the vacuum cleaner to a higher voltage than indicated in these instructions may result in damage to the vacuum cleaner or injury. this appliance has a polarized plug (one blade is wider than the other. ) This plug will fit in a polarized outlet only one way. [. . . ] ~ Monitor the dustbag change indicator and inspect all filters regularly. For best performance, the dustbag and filters should be replaced when necessary. A full bag or blocked filter will reduce the vacuum cleaner's suction power. A temperature limiter automatically switches the vacuum cleaner off if it gets too hot, see "Frequently asked questions". ~ Repairs must only be performed by an authorized service agent in accordance with national and local safety regulations. ~ If the power cord is damaged it should be replaced along with a new cable reel by Miele Technical Service. ~ Before discarding an old vacuum cleaner, please cut off the power cord and render the plug useless. Ensure the appliance presents no danger to children while being stored for disposal. SAVE THESE INSTRUCTIONS 7 Guide to the vacuum cleaner 8 Guide to the vacuum cleaner a Hand piece XXL * b Air inlet valve * c Lock release button d Three piece telescopic wand * e Telescopic wand release button * f Dust compartment lid release g Floor brush * h Carrying handle i Socket for Powerbrush j Dustbag k Dust compartment filter (pre-motor filter) l Exhaust filter * m Power cord n Cord rewind switch o Suction power selector p Park-System q On/Off s foot switch r Airflow indicator s Hose connector * t Suction hose * u Accessory clip The illustration shows the maximum number of features available in this series of Miele vacuum cleaners. Those features marked * depend on the model and may vary or not be available on your model. Some models are supplied with a Miele Powerbrush or Turbobrush as standard (not illustrated). Separate operating and maintenance instructions are supplied with these brushes. 9 Before using the vacuum cleaner Attaching the suction hose ^ Insert the elbow into the suction socket until it clicks. Use the inlet guides to direct insertion. Removing the suction hose ^ Press the release buttons at the sides of the elbow and lift the hose from the socket. 10 Before using the vacuum cleaner Connecting the handpiece and telescopic wand ^ Insert the handpiece into the telescopic wand. ^ To release the handpiece from the telescopic wand press the locking button (see arrow) and pull the handpiece away from the telescopic wand with a slight twist. Adjusting the telescopic wand This telescopic wand consists of two sections which are height-adjustable. The dustbag should be changed as the suction power is greatly reduced. This is because the air flow of the dustbag may still be high enough not to activate the marker to show maximum. The dustbag should still be changed. 19 Maintenance and care Replacing the dustbag ^ Open the dust compartment lid and raise until it clicks into place. The dustbag has a closing flap which closes automatically when the dust compartment lid is raised to prevent any dust from escaping. ^ Grasp the finger grip and pull the dustbag out of the holder. ^ Insert the new dust bag as far as it will go into the dustbag holder. Take care not to catch the dust bag in the lid. , A empty-operation-barrier will block the dust compartment lid from closing if no dustbag is inserted. Do Not Use Force! 20 Maintenance and care Replacing the exhaust filter Depending on model, the vacuum cleaner will be equipped with one of the following exhaust filters: a Air Clean An "Air Clean" filter is supplied with every box of Miele dustbags. b Active Air Clean SF-AAC 50 (black) c Active HEPA SF-AH 50 (blue) An "Active Air Clean" or "Active HEPA" filter should be changed approximately once a year. Change the filter sooner if it is obviously soiled or no longer effective. Replacing the "Air Clean" filter Do not use more than one filter at a time. ^ Open the filter frame and remove the used "Air Clean" filter with the clean corner (see arrow). If you wish to replace the Air Clean filter with an Active Air Clean filter or Active HEPA filter see "Maintenance and care - Exchanging exhaust filters". ^ Close the dust compartment lid firmly until it clicks into place. 21 Maintenance and care Replacing the "Active Air Clean" filter and the "Active HEPA" filter Do not use more than one filter at a time. [. . . ] Vacuum cleaner and accessories The vacuum cleaner and other plastic accessories can be cleaned with a damp cloth or a cleaner suitable for plastics. , Do not use abrasive, glass or all purpose cleaners!They will damage the surface. Dust compartment The dust compartment can, if necessary, be cleaned using a dry cloth, dusting brush or a second vacuum to remove any dust. Clean or replace them when necessary according to these Operating Instructions. , Do not submerge the vacuum in water. If moisture gets into the appliance there is the risk of an electric shock. 26 Frequently asked questions , Turn off and unplug the vacuum cleaner before performing any maintenance work. What if the vacuum turns off automatically? [. . . ]