User manual TORNADO TO2715HP

[. . . ] 19* Start/stop the vacuum cleaner by pushing the button at the top of the unit. 20* If you have a vacuum cleaner with remote control, the vacuum cleaner is started by lightly pressing the Max or Min button. 22* Adjust the suction power by pressing the Max-Min button on the vacuum cleaner or by pressing either the Max or Min button on the remote control. [. . . ] Hard floors and carpets: * The Max In, Max In Turbo and Max In motorised floor nozzles (7) detect the type of surface being vacuumed. * The nozzle with the pedal is set to the type of surface to be vacuumed: Position 1 for carpets (23) and position 2 for hard floors (24). * Use normal setting of floor nozzle for carpets (25) * Use the brush setting of floor nozzle for hard floors (26) Crevices, corners, etc. Max In, Max In Turbo and Max In motorised floor nozzles, are ideal for both hard floors and carpets. The Max In motorized nozzle receives power via the tube and hose, and no additional electrical connections are needed. a blue light on the nozzle indicates that the brush roller is turning. If anything should become lodged in the brush roller, the light turns off. 27 When you pause during cleaning, the tube can be attached to the rear of the vacuum cleaner. 28 When storing, the vacuum cleaner can be placed on end and the tube attached at the bottom of the vacuum cleaner. 43 It is sometimes possible to clear the hose by "massaging" it. However, be careful in case the obstruction has been caused by glass or needles caught inside the hose. Note: The warranty does not cover any damage to hoses caused by cleaning them. If something gets stuck in the vacuum cleaner: 44 Turn off the vacuum cleaner and open the cover at the front of the unit by lifting the release catch. 46 Lift the cover between the filter wells and remove anything that may have got stuck. Put the filter holder back in place and close the vacuum cleaner cover. 48 The Max In and the carpet/floor nozzles should be cleaned frequently to avoid losing suction power. (Certainmodelsonly) Always unplug the vacuum cleaner from the wall outlet before cleaning. 49 To remove the brush roller cover, push the outer latch out, and the middle cover to the left, and this will also free the wheels for cleaning. [. . . ] 49 To remove the brush roller cover, push the outer latch out, and the middle cover to the left, and this will also free the wheels for cleaning. 54/55 Remove the "cone" on the side with your finger by pulling it up and straight on. The dust container and the "cone" can now be wiped off or cleaned. [. . . ]