User manual TORNADO T6626 INSTALLATION INSTRUCTIONS

[. . . ] 28 Cleaning and care Problem solving guide / After sales service Optional accessories Electrical connection for the UK 2 Caring for the environment Disposal of packing material The transport and protective packing has been selected from materials which are environmentally friendly for disposal and can normally be recycled. are disposed of safely and kept out of the reach of babies and young children. Rather than just throwing these materials away, please recycle them. Disposal of your old appliance Electrical and electronic appliances often contain materials which, if handled or disposed of incorrectly, could be potentially hazardous to human health and to the environment. They are, however, essential for the correct functioning of your appliance. [. . . ] The manufacturer cannot be held liable for unauthorised work. 8 Preparing for use Attaching the electro suction hose ^ Insert the hose connector into the socket until it clicks into position. Removing the electro suction hose from the cleaner ^ Press the release buttons at the side of the hose connector, and lift the hose from the socket. 9 Preparing for use Connecting the handle to the electro telescopic suction tube ^ Insert the handle into the electro telescopic suction tube until it clicks into position. ^ To release the handle from the suction tube, press the locking button (see arrow) and pull the handle away from the suction tube. Adjusting the electro telescopic suction tube One part of the electro-telescopic tube is packed inside the other and can be adjusted to suit your height for comfortable vacuum cleaning. ^ Press the telescopic tube release button (see arrow) to release the tubes and adjust to the required height. Then release the button to lock the tube in position. 10 Preparing for use Using the Electrobrush Important: please observe the flooring manufacturer's cleaning and care instructions. The Electrobrush is particularly suitable for intensive vacuuming of carpets which are subject to hard wear. It is very effective at removing deep seated dirt and preventing areas of frequent use being trodden into a path. , Please note that the Electrobrush should not be used for vacuuming deep-pile rugs and carpets or valuable hand-knotted rugs and carpets, e. g. , Do not use the SEB 217 Electrobrush to clean highly variable or uneven floors. The brush might come into contact with the floor and cause damage. Connecting the electro telescopic suction tube and the Electrobrush ^ Insert the electro telescopic suction tube into the Electrobrush until it clicks into position. For further information on use and maintenance please refer to the separate instructions supplied with the Electrobrush. 11 Preparing for use Using the standard floorhead Important: please observe the flooring manufacturer's cleaning and care instructions. The floorhead can be used for all normal cleaning of carpets and rugs. It can also be used with the brush protruding to vacuum hard flooring. The use of non-Miele approved dusbags and accessories could invalidate your warranty and cause damage to your product. 21 Maintenance and care When to change the dustbag Change the dustbag when the colour marker in the dustbag change indicator fills the display, or sooner if it is no longer effective (see possible reasons for this below). Checking the dustbag change indicator ^ Attach the standard floorhead to the suction tube. Do not use any of the other floorheads or attachments as they will cause the dustbag change indicator to give a false reading. ^ Switch on the vacuum cleaner using the On/Off foot control s, and select the highest power setting on the handle. If the marker completely fills the dustbag change indicator, you should replace the dustbag with a new one. How the dustbag change indicator works The dustbag change indicator is set for normal household dust. Normal household dust would contain a mixture of dust, hair, carpet fluff, threads, grit etc. However, if the vacuum cleaner has been used to suck up fine dust, such as plaster, brick dust, cement or flour, the pores of the dustbag will become blocked very quickly. This affects the air permeability of the bag, and the marker will indicate that the bag is "full" even when it is not. If this happens you must still change the dustbag because suction power will be greatly reduced by blocked pores in the dustbag. If, on the other hand, you have vacuumed up a large amount of hair and carpet fluff which typically contains a lot of air, the indicator may fail to react even though the bag is full. Both these extremes can occur. 22 Maintenance and care Replacing the dustbag ^ Lift the release button for the dust compartment lid and raise the lid as far as it will go. ^ To remove the dustbag, hold the bag by the collar and pull it out of its holder. [. . . ] Vacuum cleaner and accessories External surfaces of the vacuum cleaner and of the accessories can be cleaned with a dry or a slightly damp cloth, or with a proprietary cleaner suitable for plastic. E-Cloth A microfibre "E-Cloth" is available from the Miele UK Spare Parts Department, which is suitable for cleaning surfaces such as stainless steel, glass, plastic and chrome without the use of chemicals. It can be washed 300 times. , Do not use abrasive cleaners, glass cleaners or all-purpose cleaners. Because of their chemical composition they could cause serious damage to plastic components. Dust compartment The dust compartment can, if necessary, be cleaned using a dry duster, brush or, if available, a second vacuum cleaner to vacuum the dust out. , Do not let the vacuum cleaner get wet. [. . . ]