User manual TOPCOM TWINTALKER 9500

[. . . ] They include fuelling areas such as below deck on boats, fuel or chemical transfer or storage facilities; areas where the air contains chemicals or particles, such as grain, dust or metal powders; and any other area where you would normally be advised to turn off your vehicle engine. Legal In some countries it is prohibited to use your PMR while driving a vehicle. Any use of the PMR must be in accordance with airline regulations or crew instructions. Turn your PMR OFF in any facilities where posted notices instruct you to do so. [. . . ] You will soon notice that PMR works best when there is a minimum of obstacles between users. 8 • • • • • • Included in the package 2 x Twintalker 9500 2 x Desktop Charger 2 x Power adapter 8 x AAA NiMh batteries User guide Card with service address and Hotline 1. 1 Installing/Removing the Belt Clip”) Lift the battery door by gently pushing the door clip (C) using your finger nail. Re-install the belt clip Twintalker 9500 5 10 Charging the batteries There are two ways to charge the battery of the PMR's : 10. Plug one end of the supplied adapter into an easy accessible electric socket and the other end into the connector on the backside of the desktop charger 28 . (See folded cover page - illustration 3) Put the radio in the charger as indicated. The charging LED 29 will turn on if it’s properly inserted and charging. (See folded cover page illustration 3) 11 Description ENGLISH See folded cover page - illustration 1 1. ON/OFF Volume knob LCD display Charger connection Headset connection TX LED ( on when transmitting) Call button Menu button – Enter the menu settings Microphone Speaker Down button – Select previous value in the menu Up button – Select next value in the menu PTT-button Antenna 3. Connect the connector of the power adapter directly to the charger connection 3 of the PMR. Charger connection Charger LED ( on when charging) 12 LCD display information See folded cover page - illustration 2 14. In order for other people to receive your transmission, they must also be on the same channel and have set the same CTCSS code or DCS code. 1 CTCSS ENGLISH • • • Press the -button 7 twice : "CTCSS" and the current CTCSS code flashes on the display. € Press the - button 7 four times, the current VOX setting flashes on the display and the VOX icon is displayed. Press the -button 11 to set the VOX sensitivity level between 1 and 3 (level 3 is the most sensitive level). Press the button 10 until ‘OFF’ appears on the display, to turn VOX OFF. 2 DCS • • • Press the -button 7 three times : "DCS" and the current DCS code flashes on the display. 10 Channel Scan Channel scan performs searches for active signals in an endless loop from channel 1 to 8. 1 Scanning for an active radio channel To disable CTCSS or DCS, select code "00" for CTCSS or for DCS in the menu. € • Press the -button 7 five times : "SCAN" and the current channel flashes on the display. 8 Monitor You can use the monitor feature to check for weaker signals in the current channel. Once an active channel is found, the scanning will stop and you can listen to the transmission. [. . . ] Try to avoid as many obstacles as possible and communicate in a clear line of sight. € The PTT -button 12 , the -button 6 and the be functional when the Button Lock is activated. 16 Display back light To activate the backlight of the LCD display, press any button except the PTT - button 12 or the button 6 . Limited Range and noice during transmission 14 Earpiece connection The connector is located on the upper side of the unit 2 . [. . . ]