User manual TOPCOM TWINTALKER 5010

[. . . ] Turn your PMR off in any facilities where posted notices instruct you to do so. Hospitals or health care facilities may be using equipment that is sensitive to external RF energy. Replacing or modifying the antenna may affect the PMR radio specifications and violate the CE regulations. Please read carefully through the following information concerning safety and proper use. [. . . ] To install the belt clip, align the pin with the hole in the backside. To remove the belt clip from the unit, push the belt clip (a), while pulling the clip away from the unit (b). 2 Battery installation 7 • • • • • • Included in the package 2 x Twintalker 5010 2 x Belt clip 1 x Duo charger 1 x Power adapter 2 x NiMH (3 x AAA) battery pack ECO User guide 1. Install the rechargeable battery pack following the polarity as shown. The metal contacts should face outwards from the radio to connect on the battery 4 Topcom Twintalker 5010 Topcom Twintalker 5010 door. or install 3 ‘AAA’ alkaline or rechargeable batteries following the polarity as shown. Earpiece connector LCD display Volume up button Monitor / scan button MON / Up button Microphone Optional power supply connector Speaker Menu / on-off / unlock button / Down button Call button Push to talk button PTT Volume down button Power / transmission LED Antenna 4. 9 Charging batteries When NiMh battery packs are installed, the desktop charger provides drop-in charging convenience. Pay attention to the mentioned voltage and compare this with the indications of the power supply. Connect the low tension plug at the end of the cable with the connector at the backside of the desktop charger. The charging LED will turn on if it’s properly inserted and charging. There is no indication on the display when the batteries are being charged. 12 LCD display information The device can also operate with 3 x AAA NiMh batteries or with 3 x AAA Alkaline batteries. Battery charge level indication 13 Using the Twintalker 5010 If the segments and icons of the displays are shown in light grey in this user guide, it indicates that they are blinking and/or selectable. 10 Battery charge level The battery charge level is indicated by the number of squares present inside the battery icon on the LCD display. • • • • + + + + 13. 1 Turning the unit on/off Battery full Battery 2/3 charged Battery 1/3 charged Battery empty To turn on: • Press and hold the -button 9 for 3 seconds. The unit will “beep” and the LCD display will display the current channel. To switch off: • Press and hold the -button 9 for 3 seconds. The unit will “beep” and the LCD display will turn blank. 11 Description See folded cover page - illustration 1 Topcom Twintalker 5010 5 ENGLISH Topcom Twintalker 5010 13. 2 Adjusting speaker volume There are 15 levels of speaker volume • 3 in stand-by-mode Press the volume up button to increase the speaker volume. [. . . ] When the counter is stopped, press the -button 10 to reset the counter. 17 Display back light To activate the backlight of the LCD display, press any button except the PTT-button 12 or the button 11 The LCD backlight will light up for 5 seconds. 14 Earpiece connection • After selecting this function, and also after resetting the counter, the measurement should be started within 5 seconds. The connector is located under the protective rubber cover on the top of the unit. [. . . ]