User manual TOPCOM BUTLER 4011C

[. . . ] Do not touch the charger and plug contacts with sharp or metal objects. Do not place the basic unit in a damp room or at a distance of less than 1. Do not use the telephone in environments where there is a risk of explosions. As this telephone cannot be used in case of a power cut, you should use a mains-independent telephone for emergency calls, e. [. . . ] Once the handset dialled is answered, keep the `#' key pressed for 3 seconds. If you cannot find the handset, briefly press the Paging key on the base unit. All handsets subscribed with the base unit will sound a signal so you can locate the misplaced handset. If you press the alphanumeric key '5', the first character (j) appears on the display. If you would like to select both `A' and `B' after each other, first press the `2' key once to select `A', wait 2 seconds until the cursor moves to the next position and then press the `2' key twice to select `B'. Press the right keys to get the following characters: Keys First press + A D G J M P T W SPACE Second press B E H K N Q U X 0 Third press / C F I L O R V Y Fourth press 1 2 3 4 5 6 S 8 Z Fifth press Press the Up or Down key repeatedly until `ADD NEW' appears on the display. Press the Up or Down key repeatedly until `PHONE BOOK' appears on the display. The first name, corresponding with these letters appears on the display. Press the Up or Down key to browse for other numbers in the Phone Book. Once the desired number appears on the display, the number will be automatically dialled once the Line key is pressed. Press the Up or Down key repeatedly until `PHONE BOOK' appears on the display. If you do, you have to restore the default settings (reset ­ see section 4. In order to be able to make and receive telephone calls, a new handset has to be subscribed to the base unit. By default, each handset is subscribed as handset 1 on the base unit upon delivery (base unit 1). the underlined procedure is only applicable to a Butler 1000 , 1010 , 1210 , 2405 , 2410 , 2450 handset and base unit!Keep the Paging key on the base unit pressed for 10 seconds until the Line/Charge indicator on the base unit begins to blink rapidly. During this minute, the base unit is in subscribing mode and you must do the following to subscribe the handset: · Press the Up or Down key repeatedly until `BASE SUB' appears on the display. Enter a number of the base unit you would like to subscribe the handset to (1-4). The RFPI code (each base unit has a unique RFPI code) appears on the display and a signal sounds when the handset has found the base unit. Enter the 4-digit PIN code of the base unit in (default PIN code is `0000'). If the base is in subscribing mode, you have to do the following to subscribe the handset: · Press the Up or Down key repeatedly until `BASE SUB' appears on the display. Enter a number for the base unit to which you would like to subscribe the handset (1-4). [. . . ] By setting the date and time, they will be shown on the display, together with the telephone number, every time a call comes in !Press the Up or Down key a few times until `SETTING' appears on the display. When `YEAR' appears on the display, enter the 2 last numbers of the year (00=2000, 01=2001, . When `MONTH' appears on the display, enter the month (01=January, 02=February, . [. . . ]