User manual TNB SECURITY LOCK CABLE MCAV3W

[. . . ] n the event of damage to the power cable 8 , I the repair may only be carried out by the manufacturer, his service centre or a suitably qualified specialist. To avoid physical injuries:  o not use the electric Multi-Purpose Slicer if D your hands are wet or you are standing on a wet floor.   up and store the electric MultiSet Purpose Slicer out of reach of children.  his device is not intended to be used by persons T (including children) with restricted physical, sensory or mental abilities or with insufficient experience and / or knowledge, unless they are supervised by a person who is responsible for their safety or they have received instruction on how to use the device from such a responsible person. [. . . ] No claims under the warranty nor a liability for damages will be accepted if they result from improper or incorrect use of the slicer. Q Before  Q First   lace the catch tray 17 below the support P table 9 and on the housing such that the sliced foods can fall in there directly and without hindrance after being cut. q Adjust  the First Usage steps the infinite slice-thickness setting (see Fig. D)  arefully remove the electric Multi-Purpose C Slicer from its packaging, remove all packaging materials and keep them together with the main packaging.  lean the electric Multi-Purpose Slicer before it C comes into contact with any foodstuffs (see also the chapter “Cleaning”). Q Setting  Through variable tightenings of the adjusting screws 16 you can determine the movement rate of the infinite slice-thickness setting 14 .  crew both of the adjusting screws 16 tight S with the screwdriver 15 .  heck, by turning the infinite slice-thickness C control knob 14 , to see if the desired movement rate is suitable. If it is not, - oosen both adjusting screws 16 for a lighter l movement rate or - ighten both adjusting screws 16 further for a t stiffer movement rate. Q Operation  Q Working  up the appliance S  pecific safety advice on the placing of the appliance 1.  Never set the electric Multi-Purpose Slicer up on a hot surface or near an open flame. 10 minutes (switch in position “I“):  et the switch for intermittent / continuous operS ation 3 to position “I“. The cutting blade 12 runs without it being necessary to hold the switch in this position. Halting continuous operation: Move the switch for intermittent / continuous operation 3 into the “0” position and wait until the cutting blade comes to a complete standstill. Intermittent operation (switch for intermittent / continuous operation in position “II“):  et the switch for intermittent / continuous S operation 3 to position “II“. The cutting blade will continue to run for as long as the switch for intermittent / continuous operation is held in this position. Halting intermittent operation: Release the switch for intermittent / continuous operation 3 and wait until the cutting blade comes to a complete standstill. Thickness – setting and cutting Set the required slice thickness using the control knob 14 (see Figure C). The settings on the scale do not correspond with the slice thickness in mm. For safety reasons the cuttingblade 12 is covered in setting “0“. If necessary, press the food to be sliced with the food holder plate 11 lightly against the food support 13 .  witch the appliance on and, whilst lightly S pressing the food to be sliced forward, guide it along the cutting blade 12 . [. . . ]  Switch the slicer off, remove the plug from the power socket and set the food support plate 13 into position “0“.  pen the blade cover 6 by pressing the O blade cover unlock button 4 . E) and screw the blade lock of the cutting blade 12 out by unscrewing it to the left.  hen taking out the blade 12 make sure that W you grasp it at its centre. [. . . ]