User manual TNB MOOVE SYSTEM

[. . . ] 8 B2 Q Introduction  Before you use it for the first time, it is essential that you make yourself fully familiar with the functions of the appliance and find out how to correctly handle electrically powered tools. Read the following directions for use as well as the safety instructions. When handing the device on to a third party, hand these instructions on, too. Q 4 Bit garage 5 Direction of rotation switch/lock 6 ON / OFF switch 7 Soft-grip 8 Battery pack 9 Battery unlocking button 10 Light 11 Torque control / drill step 12 Quick-action drill chuck 13 Status LED red 14 Battery charge status indicator green 15 Fast charger Intended purpose Q Items supplied This appliance is designed for drilling and screwing into wood, plastic and metal. [. . . ] A tool or spanner left attached to a rotating part of a device can lead to injury. By doing this you will be in a better position to control the device in unforeseen circumstances. Loose clothing, jewellery or long hair can become trapped in moving parts. G)  f vacuum dust extraction and collection I devices are fitted do not forget to check that they are properly connected and correctly used. Personal safety a)  emain alert at all times, watch what R you are doing and always proceed with caution. Do not use the device if you are tired or under the influence of drugs, alcohol or medication. One moment of carelessness when using the device can lead to serious injury. Always D use an electrical power tool that is intended for the task you are undertaking. By using the right electrical power tool for the job you will work more safely and achieve a better result. B)  o not use an electrical power tool if D its switch is defective. An electrical power General safety advice for electrical power tools tool that can no longer be switched on and off is dangerous and must be repaired. Chargers are often designed for a particular type of rechargeable General safety advice for electrical power tools / Before first use  ecurely support the workpiece. S A workpiece held in a clamp or vice is kept more securely in place than one held by your hand.  armful / noxious dusts generated from your H work represent a risk to the health of the person operating the device and to anyone near the work area. H High reaction torques may occur momentarily during tightening or loosening of screws.  f the inserted tool jams, switch off the I electrical power tool immediately. The inserted tool may jam if the electrical power tool is overloaded or is held at an angle to the workpiece.  efore you carry out any tasks on the B device, transport or store it, make sure that the direction of rotation switch is in the middle position (lock).  hildren or persons who lack the knowledge or C experience to use the device or whose physical, sensory or intellectual capacities are limited must never be allowed to use the device without supervision or instruction by a person responsible for their safety. Q Q Original ancillaries  /  accessories  se only the ancillaries and accessories U that are detailed in the operating instructions. The use of ancillaries and accessories other than those recommended in the operating instructions could lead to an increased risk of personal injury for you. Charge the rechargeable battery in the charging station for at least one hour before first use. [. . . ] When drilling into wood, metal and other materials:  With small diameter drill bits use a high drill speed.  Mark the intended position of the hole with a centre punch or a nail and select a low drill speed for drilling.  Take the rotating drill bit out of the hole frequently so that swarf or drill dust can be re-moved and the hole and tool is ventilated. Drilling in wood:  Normally you should use a wood drill with a centring point. [. . . ]