User manual TNB IMMERSION M10

[. . . ] Do not take into operation an appliance that is damaged or has been dropped. –  This appliance is not intended for use by individuals (including children) with restricted physical, physiological or intellectual abilities or deficiences in experience and/or knowledge unless they are supervised by a person responsible for their safety or receive from this person instruction in how the appliance is to be used. –  Children should be supervised to ensure that they do not play with the appliance. –  A repair to the appliance during the warranty period may only be carried out by a customer service department authorised by the manufacturer, otherwise, no additional warranty claims can be considered for subsequent damages. [. . . ] –  Do not make any unauthorised modifications or alterations to the appliance. 5 A1 ■ Protect the appliance against moisture and liquid penetration. Always replace the protective cap on the appliance when it is not in use. For safe handling of batteries observe the following safety instructions: ■ Do not throw batteries into a fire. Special caution should be exercised when handling damaged or leaking batteries. –  If you do not intend to use the appliance for an extended period, remove the batteries. GB Component description Protective cap / Test aid Measuring pins Display Battery compartment ON/SET button (On/Off switch / Measuring button) Button LED (LED on/off) Initial use Items supplied and transport inspection This appliance is supplied with the following components as standard: ▯ Construction materials- and wood moisture measuring appliance ▯ 4 x 1. 5 V Batteries (AAA/Micro/LR03) ▯ This operating manual PBUH 1. 5 A1 19 NOTICE ► Check the contents to ensure that everything is present and for signs of visible damage. Lines on the display ♦ To read the result for firewood, cardboard and construction timber, use the left scale with the symbol . ™¦ To read the results for mortar, concrete and plaster, use the right scale with the symbol . ™¦ If the measured value exceeds the maximum values of 2 % resp. ™¦ To minimise measurement errors, carry out comparative measurements at several locations. Temperature Display ♦ The temperature is indicated at the top of the display ♦ Press and hold the ON/SET Celsius and Fahrenheit. Button for 3 seconds to toggle between Pocket lamp ♦ Press and hold the button ♦ Press the button for 3 seconds to switch the LED off. Once again to switch the LED Automatic switch-off The appliance switches itself off automatically after approx. The automatic switch off is disabled when the LED switched on. 100 g 0°- 40°C Wood moisture content – guidelines for firewood 6 - 15 % moisture content = Very good calorific values 16 - 20 % moisture content = Suitable for heating, but with restrictions 21 - 44 % moisture content = Not suitable for heating Further drying required Building moisture – guidelines for concrete / screed The values with a dark background are classified as wet. [. . . ] 100 g 0°- 40°C Wood moisture content – guidelines for firewood 6 - 15 % moisture content = Very good calorific values 16 - 20 % moisture content = Suitable for heating, but with restrictions 21 - 44 % moisture content = Not suitable for heating Further drying required Building moisture – guidelines for concrete / screed The values with a dark background are classified as wet. –º To avoid irreparable damage to it, ensure that no moisture can get inside when you are cleaning the appliance. –  Clean the housing exclusively with a soft damp cloth and a mild dishwashing liquid. –  Clean the measuring pins with a damp cloth and dry them well afterwards. [. . . ]