User manual TNB CSF800

[. . . ] 5 m / s2 The vibration level given in these instructions has been measured in accordance with a standardised measurement procedure specified in EN 60745 and can be used to compare devices. Different uses of the device give rise to different vibration levels and in many cases they may exceed the values given in these instructions. It is easy to underestimate the vibration load if the electrical power tool is used regularly in particular circumstances. Note: If you wish to make an accurate assessment of the vibration loads experienced during a particular period of working, you should also take into account the intervening periods of time when the device is switched off or is running but is not actually in use. [. . . ] Failure to observe the safety advice and instructions may result in electric shock, fire and / or serious injury. Keep all the safety advice and instructions in a safe place for future reference!The term “electrical tool” used in the safety advice refers to electrical tools powered by mains electricity (by means of a mains lead) and electrical tools General safety advice for electrical power tools e)  hen working outdoors with an W electrical power tool always use extension cables that are also approved for use outdoors. The use of an extension cable suitable for outdoor use reduces the risk of electric shock. F)  se a residual current device (RCD) U for protection if operating the electrical power tool in a moist environment is unavoidable. Loose clothing, jewellery or long hair can become trapped in moving parts. G)  f vacuum dust extraction and collection I devices are fitted do not forget to check that they are properly connected and correctly used. Personal safety a)  emain alert at all times, watch what R you are doing and always proceed with caution. Do not use the device if you are tired or under the influence of drugs, alcohol or medication. One moment of carelessness when using the device can lead to serious injury. B)  Wear personal protective equipment and always wear safety glasses. Service a) ave your device repaired at the serH vice centre or by qualified specialist personnel using original manufacturer parts only.  se only the accessories and additional U equipment referred to in the instructions. The use of tools or other accessories which are not recommended in the instructions may represent a risk of injury. Q Operation  Q Turning  S  afety instructions for motor carving devices In order to avoid injury, fire and health hazards:  ecure the work piece. There is a danger of injury from splintering materials flying into your eyes etc. During prolonged working with wood and particularly if materials are processed which produce dusts that are hazardous to the health.  o not soak materials or areas which D are to be worked on with solvent-containing liquids. Shaving of the materials may produce harmful / toxic vapours.  aterial containing asbestos must not M be processed with this device. Under no circumstances should you prop  up your hands next to or in front of the the Device On / Off nsert the mains plug into a socket. I Switching on:  ress the ON / OFF switch 1 to the “I” position. [. . . ] This product is for private use only and is not intended for commercial use. The warranty is void in the case of abusive and improper handling, use of force and internal tampering not carried out by our authorized service branch. The warranty period will not be extended by repairs made unter warranty. Any damage and defects extant on purchase must be reported immediately after unpacking the appliance, at the latest, two days after the purchase date. [. . . ]