User manual TIVOLI AUDIO SONGBOOK

[. . . ] OWNER'S MANUAL SongBook TM Important Safety Instructions 1. For example, do not use near a bathtub, in a wet basement, near a swimming pool, and the like. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Do not defeat the safety purpose of the polarized or grounding-type plug. [. . . ] Press the Time Set button a third time to store the settings (Figure 4). When the unit is On, the clock will appear in small format in the upper right corner. NOTE: Non-US models use a 4 hour clock format. Figure 5 Figure Figure 7 8. Press and hold the Time Set Button to set the Alarm time until a beep is heard to confirm you have entered the Alarm Time Set mode. Press the Tune Up/Down buttons briefly to change each hour or press and hold to rapidly change the hours. "PM" will appear for afternoon/evening hours but there is no "AM" designation for morning hours. Now press the Time Set button to adjust the minutes using the Tune Up/Down buttons (Figure 7). NOTE: Non-US models use a 4 hour alarm format. Figure 8 Figure 9 B. To set the Alarm to wake: Set the SongBook to the FM or AM station you wish to wake to and that will be broadcasting during the time you wish to wake (or set to Off or Aux to wake to an increasing beep) and adjust the volume level accordingly. A beep tone will be heard confirming the Alarm is set to wake and the word "Alarm" will show on the display. The SongBook will go into Standby mode and the display will show "Standby" (Figure 8). If the Alarm has been set and the SongBook is in the Off position, the alarm wake time will show in the upper right hand corner. When the alarm activates, the LCD will light up and the word "Alarm" will flash (Figure 9). Should you opt to wake to the beep, the beep will sound for 0 seconds, then pause for 0 seconds, then resume for another 0 seconds. This pattern will repeat for up to one hour or until the Alarm button is pressed. If the alarm is set and activates but the batteries are too weak to play the radio, the beep will sound instead, provided there is enough battery power remaining. The LCD will show an "E" to indicate the batteries are empty (Figure 8). Figure 0 C. To Cancel the Alarm: When the alarm activates, press the Alarm button to cancel the alarm and the word "Alarm" will disappear from the display, the display will flash the word "Off" (Figure 0) for several seconds, and the unit will go into Standby. Changing the source knob to another position will cancel Standby mode. Once the alarm activates, if it is not manually turned off, the Alarm will shut off automatically after approximately 0 minutes to preserve the batteries and the display will say "Standby". 7 Guide to Features (Left Side Panel): 3 2 1 1. 12VDC/500mA: Connect the included external power supply to this input, or use an optional A fused VDC adaptor for operation in a boat or camper. When disconnecting the power supply from the wall outlet, never pull it by the cord. [. . . ] In the event the product is returned during the warranty term and is eligible for service under this Limited Warranty, we will repair or replace any defective parts within a reasonable period of time and free of charge. THIS LIMITED WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS SUBjECT TO SPECIFIED CONDITIONS. YOU MAY ALSO HAVE OTHER LEGAL RIGHTS WHICH APPLY TO THE PRODUCT YOU HAVE ACQUIRED. SOME PLACES DO NOT ALLOW THE ExCLUSION, RESTRICTION, OR MODIFICATION OF CERTAIN IMPLIED RIGHTS OR THEIR EFFECT. [. . . ]