User manual TIVOLI AUDIO MODEL THREE DUAL ALARM SPEAKER

[. . . ] DO NOT TURN THE ALARM THUMBWHEEL CLOCKWISE OR YOU MAY DAMAGE THE MECHANISM. The alarm tone will activate when the clock time roughly coincides with the setting of the alarm hand. To turn the Alarm OFF, press the Alarm button again and the LED will extinguish. The Model Three Dual Alarm speaker can be set to wake to the alarm tone only. Never use harsh cleansers or solvents or abrasive pads. [. . . ] ALARM: Once you have set the wake-up time using the Alarm Thumbwheel, push this button in to activate the alarm and the corresponding green LED will light. Push the Alarm button out to deactivate the alarm and the LED will extinguish. This Alarm button controls the Model Three Dual Alarm Speaker only and has no affect on the Model Three clock radio's alarm, and viceversa. ALARM THUMBWHEEL: Rotate the aluminum thumbwheel counterclockwise until the alarm hand points to the designated time you wish to wake to. SNOOZE (top of cabinet): When the alarm tone sounds, press, hold, and then release the Snooze button to silence the alarm for approximately 5 minutes. This Snooze button controls the Model Three Dual Alarm Speaker only and has no affect on the Model Three clock radio's alarm or radio. Likewise, the Model Three clock radio's Snooze button will not affect the Model Three Dual Alarm Speaker's alarm tone. CLOCK: This analog clock features a fine mechanical quartz movement for superb accuracy. The clock operates off of a single "AA" battery so power failures will not affect the clock's accuracy. It is normal for the light to take several seconds to extinguish if the power supply is disconnected. POWER CORD PROTECTION Power-supply cords should be routed so that they are not likely to be walked-on or pinched by items placed upon or against them. Pay particular attention to cords at plugs, convenience receptacles, and the point where they exit from the product. This symbol is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. LIGHTNING For added protection for this product during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. This will prevent damage to the product due to lightning and power-line surges. OVERLOADING Do not overload wall outlets, extension cords, or integral convenience receptacles as this can result in a risk of fire or electric shock. OBJECT AND LIQUID ENTRY Never push objects of any kind into this product through openings as they may touch dangerous voltage points or short-out parts which could result in fire or electric shock. SERVICING Do not attempt to service this product yourself as opening or removing covers may expose you to dangerous voltage or other hazards. DAMAGE REQUIRING SERVICE Unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions: a. If the product does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions as an improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the product to its normal operation. When the product exhibits a distinct change in performance ­ this indicates a need for service. REPLACEMENT PARTS When replacement parts are required, be sure the service technician has used replacement parts specified by the manufacturer or have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock or other hazards. SAFETY CHECK Upon completion of any service or repairs to this product, ask the service technician to perform safety checks to determine that the product is in proper operating condition. [. . . ] Be sure the alarm button is in the OFF position when setting the time. BATTERY BACK UP: Remove the battery cover and install a 1. 5V "AA" battery, observing correct +/- polarity. The clock operates off of the battery continuously and the battery also acts as a back up. In the event of a power failure, the battery back-up will maintain the clock's operation and sound the alarm tone if the alarm button is in the ON position, provided a fresh battery (not included) is correctly installed. [. . . ]