User manual THORENS TD 850

[. . . ] Instruction Manual TD 800 Series Dear Thorens customer, many thanks for your confidence into our product, the record player of the 800 Series. With the purchase of your record player you acquired a precision instrument for the playback of records. To make him sound perfect there is some attention necessary for setup and handling. [. . . ] Damage, which take place via neglect of the operating instruction or via outside mechanical effects, as well as transport damages are not taken off by the warranty. The warranty extends only to the turntable and the motor inclusive power pack. Tone arm and pick-ups have the warranty granted by the respective manufacturer. Sending the warrranty card could be done by e-mail to technik@Thorens. ch or by mail to THORENS EXPORT COMPANY LTD IM JUNKHOLZ 44 · CH-4303 KAISERAUGST-BASEL / SWITZERLAND Use of the turntable Your turntable has been built to be used in closed rooms. Make sure that there is not water or humidity close to the turntable or the PS 800 power supply. In any case of a damage or question please contact your importer or us. Setup of the turntable To avoid damages during transport your turntable comes carefully packed and separated. Place the included plates for the spikes where you want to have the turntable playing. Check the correct adjustment with a spirit level. Now place the turntable platter with his axle over the bearing and let it slide into it. Take care that the front end of the axle is not crashing onto the bearing bottom. Now put the feltmat on the platter Connecting the motor Connect the motorcable with the power pack Ps 800. Make sure that the ON/OFF switch at the front side is in Off position and the speed selector is on 33 rpm. Then plug in the 3-pin connector from the external AC/AC adaptor to the plug on the back of the PS800. Anti Skating(Bias) adjustment Set the bias adjustment knob to the same number as the tracking force. NOTE: This setting is not critical and a figure of 1-1. 5g will normally be suitable for moving magnet cartridges and 1. 5-2g for most of the MC cartridges. The Ps 800 power pack gets warm make sure that it is standing free so that the air can circulate. Because of an overload protection you must let the turntable run for 33 rpm before switching to 45rpm. [. . . ] Dimensions (wxdxh): 420 x 350 x 125 mm Weight: 8 kg Colors available: Aluminium, black TD 810 Drive System: Thorens Belt drive Motor: Fully electronically regulated AC-Synchronius motor Speed: 33, 45 rpm Speed Select: electronically Platter: 300 mm / 4 kg, non magnetic Tonearm: Thorens TP 250 Antiskating: magnetic Automatik: none Switch off: none Capacity of signal leads: 120 pF Power Supply: Electronically regulated Power Supply for AC Motor. Dimensions (wxdxh): 420 x 350 x 135 mm Weight: 12 kg Colors available: Aluminium, black TD 850 Drive System: Thorens Belt drive Motor: Fully electronically regulated AC-Synchronius motor Speed: 33, 45 rpm Speed Select: electronically Platter: 300 mm / 4 kg, non magnetic Tonearm: Thorens TP 300 or TP 250 with VTA adjuster Antiskating: magnetic Automatik: none Switch off: none Capacity of signal leads: 120 pF Power Supply: Electronically regulated Power Supply for AC Motor. Dimensions (wxdxh): 420 x 350 x 165 mm Weight: 22 kg Colors available: Aluminium, black Manufacturer: THORENS EXPORT COMPANY LTD IM JUNKHOLZ 44 · CH-4303 KAISERAUGST-BASEL / SWITZERLAND FAX:++41 (0)61 813 03 39 info@thorens. ch [. . . ]