User manual THERMADOR PHE INSTALL

[. . . ] When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utilities. To properly exhaust air, be sure to duct air outside - do not vent exhaust air into spaces within walls, ceilings, attics, crawl spaces, or garages. L'écoulement comburant pour le fonctionnement sûr du matériel de la combustion du combustible peut être affecté par le fonctionnement de cet appareil. Suivre la directive des fabricants du matériel chauffant et les normes de sécurité tel que ceux publiées par l'Association du Protection de Feu National (NFPA), et la Société Américaine pour les Ingénieurs de Chauffage, de Réfrigération et de Climatisation (ASHRAE), et les autorités des codes locales. [. . . ] Both vertical and horizontal discharge are possible with either mounting method. Discharge Direction: Discharge Direction: The PHE hood is shipped ready for vertical discharge. To change to horizontal discharge simply move the two plates marked A in Figure 1 to the top of the hood. Each plate is held in place by two sheetmetal screws. Transition: Assembly of the T ransition: The transition supplied with the PHE hood mounts to the top or rear of the hood depending on the discharge direction. Align mounting holes at base of transition with mounting holes on 1/2" flange located at the top or rear of the hood depending on direction of discharge. Fasten transition to hood using 6 (4 mm x 9. 5 mm) screws (included with hood). Remove tape holding damper closed. Figure 1 Page 4 Wall Mount Installation The desired installation height of the PHE is the user's preference. Figure 2 shows a typical installation of the hood with two duct covers. Thermador offers 6" and/or 12" duct covers to fill the space between the hood and ceiling. One 6" and one 12" duct cover have been used in this installation. Hood Installation Height After the hood installation height has been determined draw a horizontal line at a distance above the cooktop equal to the desired hood installation height plus 15. 5". This line is the mounting location of the wooden bracket shipped with the hood. Draw a vertical line along this centerline up to the horizontal line drawn in step 1. The PHE is mounted to the wall using a wooden bracket shipped with the hood. Mark the centerline of the bracket. Figure 2 covers as appropriate to accommodate ceiling height and desired hood height. Find studs behind the drywall by tapping the wall or using a stud finder. Locate one stud on either side of the cooktop centerline to use for mounting the wooden bracket as shown in Figure 3. 7. Use 2-4 (6mm x 80 mm) screws to attach the bracket to the wall as shown in Figure 3. On the wood bracket mark the locations used to hang the hood according to Figure 4. Figure 3 5. Align the top of the wood bracket along the horizontal line drawn in step 1. Drill a 3" deep 1/8" tap hole through the wooden bracket, drywall, and into the stud. Figure 4 9. Screw 2 (4. 2mm x 18 mm) screws into the wood bracket leaving 1/4" of the screw exposed for hanging the hood. Page 6 11. [. . . ] Dimension A in Figure 11 depends on the hood model being installed and can be located in the table above. " " Figure 11 Page 9 3. For horizontal discharge use Figure 5 for the geometry of the cutout required for clearance of the transition. Install two wall anchors as described in step 15 on the previous page. Page 10 Installing an Integral Blower: The PHE hood can be installed with Thermador's VTN1000Q blower. In the 30" PHE model remove the two spacers A shown in Figure 12. [. . . ]