User manual THERMADOR 19-10-273L

[. . . ] Installation work and electrical ING: wiring must be done by qualified perCAUTION: FOR GENERAL sons in accordance with all applicable VENTILATING USE ONLY. DO codes & standards, including fire-rated NOT USE TO EXHAUST HAZ- construction. Use this unit only in the manner through the flue (chimney) of fuel burnintended by the manufacturer. [. . . ] Always turn hood ON when cooking at high heat or when cooking flaming foods. Always use cookware appropriate for the size of the surface element. WARNING: - TO REDUCE THE RISK OF INJURY TO PERSONS IN THE EVENT OF A RANGE TOP GREASE FIRE, OBSERVE THE FOLLOWING: A. SMOTHER FLAMES with a close-fitting lid, cookie sheet, or metal tray, then turn off the burner. If the flames do not go out immediately, EVACUATE AND CALL THE FIRE DEPARTMENT. DO NOT USE WATER, including wet dishcloths or towels ­ a violent steam explosion will result. Use an extinguisher ONLY if: 1) You have a Class ABC extinguisher, and you already know how to operate it. 4) You can fight the fire with your back to an exit. PAGE 1 RECOMMENDED FOR USE OVER CONVENTIONAL DOMESTIC GAS AND ELECTRIC RANGES AND COOKTOPS. I FOR USE WITH H/HB/HT HOOD SERIES: FIGURE 1 Longer Bracket (Provided with H/HT Hoods) 7-1/2" 1. 2. Remove the Z-shaped bracket from the VM410 ventilator and discard. Remove the blower mounting bracket from the VM410 and replace with a longer bracket provided with the hood. Insert one end of the blower mounting bracket into the ventilator mounting channel located in the rough-in plate, and slip the other end of the bracket into the well stud (located in the rough-in plate) and tighten it with the flange nut (provided with the hood). Plug the ventilator cord into the receptacle located inside the hood assembly. Hex Nut Attach the transition (3-1/4" x 10") to the top of the rough-in plate, using the two shipping screws. Seal all joints between the rough-in plate and the transition with duct tape. 8" 12-3/4" VM410 3. FIGURE 2 H/HB/HT HOOD SERIES 4. [. . . ] Motor grounded to blower thru green ground wire. FIGURE 3 ­ VERTICAL DISCHARGE Backdraft Channel Damper Flange Grommet Hanger Rod · Ventilator Scroll Bracket Washer Wing Nut Flange FIGURE 4 ­ HORIZONTAL DISCHARGE (not for Models H55, VCH8 or VCH9) Flange Grommet Hanger Rod 3-3/4" SERVICE INSTRUCTIONS 1. Grease should not be allowed to accumulate on hood or ventilator surfaces. Be sure no water enters motor as this can cause damage. Ventilator Flange Scroll Bracket Washer Wing Nut Channel Thermador reserves the right to change specifications or design without notice. [. . . ]