User manual THEBEN LU361PE-S

[. . . ] (cos j =1) voltage free contact (Load II is uncontrolled by LUX value, it can work at any light level). LU 361 PE: Single load control (D1-D2): 10A max (cos j =1) voltage free contact. [. . . ] And refer to wiring diagram to connect it in parallel with the first sensor (LU 361 PE2) in power box (See Fig. Refer to wiring diagram to connect wiring into power box terminal then replace protecting-cover and tighten it with screws (Voir Fig. Organize all wirings, then fix the power box with screws and mount it in the ceiling (Voir Fig. Insert two spring-clip pins into hole and press the sensor upward, then spring-clip pins will automatically stick on ceiling. â· Adjust sensor position and assure its bottom fixed tightly on ceiling (See Fig. Wipe gently with a clean and dry cloth if the sensor surface is dirty. Slightly pull out sensor head with a screwdriver at OPEN mark before sensor head adjustment (See Fig. LED can be regarded as indicator when performing a walk test without connecting any loads. Walk Test The purpose of the walk test is to check and adjust the motion sensor detection range. Turn "METER" knob to "7m", "TIME 1" knob to "test", then you can carry out a walk test and it is uncontrolled by LUX (See Fig. When first time switches the power n or power is re-supplied again after the power is shut off, LED will turn on for 40 secs. During the time of warming up, there is no output for LOAD I if it is in test & impulse mode, otherwise it has permanent output as LOAD II. [. . . ] Avoid aiming the sensor toward any heat sources such as air conditioners, electric fans, heaters or any highly reflective surfaces. There are heat sources or any objects such as bushes which may sway in the wind within the detection coverage. [. . . ]