User manual THEBEN LU 102-180

[. . . ] do not adjust System Channel to "A" position and Unit Channel to "1" position on all HF Theben series. Though HF Theben series provide 256 combinations for channel settings, the best for the user is to use 255 combinations and exclude one combination A1 from your channel setting because A1 is very easy to get interference from other similar product in the market that eventually makes wirefree device abnormally working. Please follow the steps below to change the channel setting of Transmitter LU 102/180 HF. Turn sensor head until the rubber cap can be seen where channel switches are located inside. [. . . ] Choose a proper installation position for Transmitter LU 102/180 HF where can work excellently with the combining Receiver. (3) The 500W halogen light of Transmitter LU 102/180 HF is facing down and the sensor head is 30° forward (See Fig. Avoid Nuisance Triggering Transmitter LU 102/180 HF can be activated by any large animal, light reflective surface, heat source, or a moving object. ⷠAvoid the object moving directly toward the motion detector that brings the less sensitivity of detection. Have the object move across the pattern zone that brings more sensitivity of detection (See Fig. Less sensitive by directly moving toward the motion sensor Do not aim the sensor toward any kind of lighting sources (See Fig. Avoid having the sensor toward the area or the object whose surfaces is highly reflective or is subject to rapid changing in temperature, such as the pool, etc. Installation procedure Note: Before starting to install Transmitter LU 102/180 HF, please test and make sure Transmitter LU 102/180 HF and the combining receiver can work normally in the selected zone. Loosen the screws of the front case with a screwdriver and the screws will not fall down, will stay at front case's screw holes (See Fig. Break the knock-hole of the back case (knock-hole 1 or knockhole 2 as per your requirement) of the junction box. Fix the rubber grommet to the knock-hole and have the power wire through the knock-hole (See Fig. 12 red blue brown white white yellow/green After wires connection, fix the wires with cable clamp (See Fig. Fix the metallic bracket of 500W halogen light to the desired position with two screws (See Fig. Fix the body (sensor with halogen light) onto the mounting bracket (See Fig. Usage of lens shielding label In order to reduce detection coverage, you can use lens label, which is supplied with this instruction manual to cover transmitter's lens. 17 shows various detecting patterns while use the lens label in different When environment is applicable for LUX, trigger the transmitter LU 102/180 HF, LED of LU 102/180 HF turns on for about 5 seconds and turns off then. At the same time, the load controlled by LU 102/180 HF turns on and turns off too. the load's light-up time is decided by the time set of the Transmitter LU 102/180 HF. After time set reaches, LU 102/180 HF can be re-triggered and LED may light on for about 5 seconds and light off. Before time set reaches, re-trigger the sensor, the combining receiver is able to receive the signal and time set re-count then, but LED does not light on again. [. . . ] Responding Table of ON/OFF Signals Transmitter and Receiver inter work by means of sending ON or OFF signal from a Transmitter to its combining Receiver and correspondingly a Receiver receives the signal from the combining Transmitter and reacts to the signal received. Following is the echoic table between transmitters and receivers of HF Theben series. When Transmitter LU 102/180 HF fails to work normally, check assumptive problems and suggested solutions in following table that will be hopeful to solve your problem. Make sure Transmitter LU101-180HF is mounted within the detection range. [. . . ]