User manual THEBEN ECO-IR 180A@ECO-IR 360A

[. . . ] Always disconnect the power supply before mounting/dismounting the ECO-IR. The national and local specifications for handling electrical equipment must always be observed. Read the operating instructions carefully before mounting or putting the ECO-IR into operation. [. . . ] Connections via external relays External contactors or relays must be used to connect loads >1. Important Inductive loads must be interference-suppressed with suitable spark extinguishers (e. 5m, larger movements are required and the detection areas of multiple detectors should overlap at their edges. In order to ensure that persons are detected correctly, the detection range must not be impaired by office equipment, partitions, plants etc. Detection of movements, not seated persons, rooms with clear overview. ) Detection of seated persons with low movement, rooms without a clear overview, difficult activities, large distance from detector (reading rooms, laboratories, workshops, high-precision assembly areas, computer rooms etc. After you have defined the settings, connect the upper part to the power section. Each time the sensor head is attached to the power section or after the power supply is connected, a startup phase (90 sec. the lighting system lights up continuously and the ventilation system is in operation. In the subsequent servi ce phase, the ECO-IR responds immediately to changes in brightness in order to test the set brightness switching value (Lux) quickly. The lights can be switched off by "blinding" the sensor with a torch. Repeat the setting procedure if it is necessary to modify one of the three variables. Push the safety lock inwards as far as possible after the test (between the sensor head and the power section) (Fig. It may be necessary to correct the setting by 1 - 2 scale divisions depending on the mounting location (proximity of windows), incident light, furniture, reflective properties of the floor and walls, glare caused by lights, sensitivity to light of the user etc. [. . . ] After the service phase, the system response to a change in brightness is delayed to prevent sudden activation / deactivation. Heater, halogen spots, incandescent lamps), close open doors and windows, are other moving objects (curtains, suspended signs) or domestic animals present?Inductive loads must be fitted with suitable spark extinguishers by qualified technicians (e. [. . . ]