User manual THEBEN ATON 3-P

[. . . ] â· Able to control total 64 different lightings and appliances. Transmitter and Receiver communicate each other by having the same channel. Transmitter ATON 3-P has been preset its System Channel at I before it is exfactory (See Fig. [. . . ] The user can respectively change the system channel and fix the unit channel at "5, 7, 9, 11" according to his preference. Please make sure the channel settings on transmitter and receiver are identical. However, if the user finds the transmitter ATON 3-P and Receiver have the same channel setting with other wireless device around them, a new channel combination is DEFINITELY required. Please follow steps below to change the channel settings of Transmitter ATON 3-P. Loosen the screws of cover with a crosshead screwdriver and take it off from the button case (See Fig. â· Make sure the transmitter and receiver are set with the same channel i. In order to obtain better signal transmission performance, please have ATON 3-P held at least 1 meter high from floor, while the signal is emitting. When combining chime or alert receiver has no dimmer function, ATON 3-P can only activate the receiver, but can not DIM control the receiver. The more of activating frequency and the lower of environmental temperature is, the sooner the power consumes. We like to remind you to take off the battery when the power is insufficient or you will be long period not to use the Transmitter ATON 3-P. In addition, please note that reverse polarity may be subject Transmitter ATON 3-P to damage (See Fig. When the battery is in low battery status, LED gets faint or it becomes difficult to operate the receiver, please replace the battery. Loosen the screws of cover with a crosshead screwdriver and take it off from the bottom case (See Fig. Cover the bottom case and tighten the screws with a crosshead screwdriver. [. . . ] Cover the bottom case and tighten the screws with a crosshead screwdriver. When Transmitter ATON 3-P fails to work normally, check assumptive problems and suggested solutions in following table that will hopefully solve your problem. Make sure no other products with the same codes and frequency affect the reception and transmission of combining receiver and transmitter. [. . . ]