User manual TELTONIKA AT1000 QUICK START GUIDE V1.1

[. . . ] If the device is damaged, the power supply cables are not isolated or the isolation is damaged, before unplugging the power supply, do not touch the device. All wireless data transferring devices produce interference that may affect other devices which are placed nearby. The device may be fitted only by qualified personnel. The device must be firmly fastened in the predefined location. [. . . ] Driver/softaware download link 2 2. 1 PREPARATION Software requirements · · Windows XP with SP2 or later, Windows Vista, Windows 7 MS . NET Framework V3. 5 or later (http://www. microsoft. com or http://avl1. teltonika. lt/downloads/tavl/Framework/dotnetfx35setupSP1. zip). 2. 2 Drivers Teltonika website: Please download Virtual COM Port drivers from http://avl1. teltonika. lt/downloads/AT1000/vcpdriver_v1. 1_setup. zip. IMPORTANT: AT1000 must be connected to PC when installing drivers! 3 3 PREPARATION OF THE DEVICE Open AT1000 device REMOVE INULATING TAPES Open SIM card lid and insert the SIM card Close SIM card lid Push SIM card lid in the shown direction to lock it and assemble AT1000 4 4 Connecting AT1000 to PC Figure 1. Connecting micro USB cable to AT1000 When AT1000 is connected for the first time to PC, you will be prompted with 'Found New Hardware' window. Click 'Cancel' to stop automatic installation process. Figure 2. Found New Hardware window 5 Extract and launch VCPDriver_V1. 1_Setup. exe. This driver is used to detect AT1000 device connected to the computer. Driver installation window Installation wizard will prompt you with several windows telling that software did not pass Windows Logo test. Windows Logo pass window 6 Setup will continue installing drivers and will display a window about successful process in the end. Successful installation window Note: if drivers did not install successfully or device is not recognized, please make sure that device is connected to PC and reinstall the drivers. 5 Batteries Figure 6. Inserting the batteries. 7 AT1000 is autonomous device which uses two R14 (IEC 60086 standard) batteries. Batteries used in this device are single charge Li based type and should have the following parameters: · Voltage: 3. 6V · Nominal capacity: 5500mAh · Max pulse current not less than: 2000mA Teltonika recommended batteries are available for sale from Teltonika office or distributors. Only with these batteries correct device operation and (or) prevention of permanent damage to device is guaranteed. Warning: use only the same sort of batteries in pair and do not mix old batteries with new ones. Note: if inserting the batteries for the first time, make sure insulating tape is removed!In order not to discharge batteries, please remove them if not using the device. After inserting new batteries to the device, please remember to reset the battery level counter in the configurator. If new batteries are not inserted, do not try to reset this counter (more details about the battery level counter are described in user manual documentation). 6 Configurator AT1000 Configurator is software used to setup the device. Please download latest version of AT1000 Configurator from Teltonika webpage: http://avl1. teltonika. lt/downloads/AT1000/. To use Configurator with AT1000, make sure that batteries are inserted in the device and it is connected to PC. [. . . ] COM port: click this drop-down list to choose which COM port is used by AT1000 to connect to PC. This button is used when you connect AT1000 to PC while Configurator software is already launched, but it did not detect Virtual COM Port yet. 8 UPDATING FIRMWARE TO THE LATEST VERSION Teltonika is constantly working on improvement of the devices, and strongly recommends using the latest versions of the firmware. AT1000 Updater is software used to update the device with the latest firmware (FW) version. [. . . ]