User manual TELEX AUDIOCOM SS2002 SUPPLEMENTAL INFORMATION

[. . . ] Audiocom SS1002/SS2002 Supplemental Information Installing the Box to the Faceplate General Instructions If you ordered SS1002/ SS2002 boxes and faceplates separately, use these instructions to assemble the speaker stations. [. . . ] (Or in the case of the "U" box, connect wires from the intercom system to the terminal strip. ) To insert a wire into the terminal strip, push back the green lever on the top of the terminal as shown, then insert the wire and release the lever. XLR Connector on Box Pin 1 Pin 2 Pin 3 TABLE 1. SS1002 Terminal Strip on Circuit Board TB1-1 TB1-3 TB1-4 Description DC Common Audiocom Channel audio low and +24VDC phantom power Audiocom Channel audio high and +24VDC phantom power wire connections for use in Audiocom System XLR Connector on Box Pin 1 Pin 2 Pin 3 TABLE 2. SS1002 Terminal Strip on Circuit Board TB1-1 TB1-3 TB1-4 Description Common Clear-com power input Clear-com audio / call signal wire connections for use in Clear-com System 9330-7627-000 Rev C 07/2009 TABLE 3. SS2002 wire connections for use in Audiocom System Terminal Strip on Circuit Board TB1-1 No connection TB1-3 TB1-4 TB1-5 TB1-6 Audiocom Channel 1 audio low and +24VDC phantom power Audiocom Channel 1 audio high and +24VDC phantom power Audiocom Channel 2 audio low and +24VDC phantom power Audiocom Channel 2 audio high and +24VDC phantom power Description Common XLR Connector on Box Pin 1 Pin 2 Pin 3 Pin 4 Pin 5 Pin 6 TABLE 4. [. . . ] When connected as shown, Clear-com Line A corresponds to SS2002 Ch 1 and Clear-com Line B corresponds to SS2002 Ch 2. Step 2: Assemble the Faceplate to the Box. [. . . ]