User manual TELEMECANIQUE ALTIVAR 31

[. . . ] Congratulations, too, on selecting one of the "first family" of water conditioners in the prestigious Culligan Medallist Series. With Culligan's many years of knowledge and experience in water treatment, you can be confident that the model you selected has been designed and engineered to provide years of service with a minimum of care and attention. A water softener cannot correct this problem and so its printed warranty disclaims liability for corrosion of plumbing lines, fixtures or appliances. If you suspect corrosion, your Culligan Dealer has equipment to control the problem. [. . . ] Toggle between "SOF" (Softener) and "FIL" (Filter) with the "+" or "-" key. Note: Changing this setting will cause the unit to load the Filter or Softener defaults. SOF OFF 4. The display will blink "dIP4" for 3 seconds and then show the current status. Toggle between "OFF" (Timeclock backup is off) and "ON" (Timeclock backup is on) with the "+" or "-" key. Note: Changing this setting will not change any of the programmed values and will load the default Timeclock Backup value of 3 days. Note: This option will only be available when the flowmeter is plugged into the control. The display will blink "dIP5" for 3 seconds and then show the current status. Toggle between "En" (English units) and "MET" (Metric units) with the "+" or "-" key. The display will blink "dIP6" for 3 seconds and then show the current status. Toggle between "12 Hr" (12 hour clock) and "24 Hr" (24 hour clock) with the "+" or "-" key. The display will blink "dIP7" for 3 seconds and then show the current status. For example, if 87 is shown in the display, the control will regenerate after 870 gallons have passed through the meter. 71 OR 87 Timeclock Mode Press the "Status" key after programming the brine draw/slow rinse time. The display will blink "CAP" for 3 seconds and then display the number of days between regenerations. (1-42 days) Exiting Program Mode From Step 6 (or step 7 if it is active) press the "Status" key. Note: The control will exit the programming mode if no key press activity takes place within one minute. 20 Regeneration There are several conditions that will cause the control to trip a regeneration. The "REG" enunciator will light when the control has signaled for a regeneration. The "REG" enunciator will flash while the control is in regeneration. When the Soft-Minder® meter has recorded the passage of a predetermined number of gallons. At the preset time, when the number of days without a regeneration is equal to the Timeclock Backup setting. At the preset time, when the "REGEN" button is depressed once. Immediately, when the "REGEN" button is depressed for three seconds. Immediately, if power to the unit has been off for more than 3 hours and time of day has been restored. [. . . ] Specify number of feet 47 Records and Data Important Data on Your Water Conditioner It is advisable to have the salesperson or installer fill in the information below for your future reference. If this has not been done, please ask for it, as it is necessary if you contact your dealer. Regeneration Interval __________ days (Time clock models) Gallons to signal __________ gallons (Soft-Minder® models) Catalog No. Tank Serial No. Number of people in household WATER ANALYSIS Total Hardness _______ (gpg) Other _________________________________________________________________________ _________________________________________________________________________ Total Iron _______ (ppm) pH (acidity)____________ 48 Culligan Medallist Series® Automatic Water Conditioners You have just purchased one of the finest water conditioners made. [. . . ]