User manual TELEFUNKEN TF 72

[. . . ] 2 Antenna output (DM 500-C/T) You can optionally connect your TV or VCR here. 3 LNB input (DM 500-S) Connect the coaxial cable from your LNB here. Remember to shutdown your Dreambox completely in order for the receiver to work. 5 Video output (FBAS) You can optionally connect your Dreambox to a TV using a RCA/Chinch cable. [. . . ] No circular polarization: If you scan anything other than a C-Band satellite please check the checkbox. After you started searching you will see the progress bar and the estimated remaining time. You can always abort the searching by pressing the Exit-Button several times. Once your Dreambox is done searching you will see this menu on the right. 48 User Manual Dreambox DM 500 english You will now be prompted if you want to scan another satellite. Press the green Options-Button if that is the case and you have setup another satellite in the satellite list. Automatic multisat scan (DM 500-S) If no OSD menu is visible on your screen, press the Menu-Button to open the main OSD menu. Navigate to the option “Setup” and press the OK-Button to select. Navigate to the option “Service Searching” and press the OK-Button. Navigate to the option “Automatic Multisat Scan” and press the OK-Button. This option will scan all satellites in your satellite list without asking you if you want to scan any other satellites. 55 User Manual Dreambox DM 500 english Follow the instructions in this menu. Press the Navigation-Buttons to reach the desired option and use the OK-Button to change them. Network search: The NIT holds the Information about the Satellites and the TV/Radio- Programs. (NIT = Network Information Table) Extended network search: Set a check to scan the NIT from other Transponders. (BAT = Bouquet Association Table) Press the green Options-Button to save your settings. 56 User Manual Dreambox DM 500 english Through this menu you can a transponder to a satellite. Using the Numeric Keypad of your remote control enter the transponder frequency and symbol rate. After you have made your changes to the transponder and satellite list, press the Exit-Button to leave the menu. Service organizing – Adding a new Bouquet If no OSD menu is visible on your screen, press the Menu-Button to open the main OSD menu. Navigate to the option “Setup” and press the OK-Button to select. Navigate to the option “Service Organizing” and press the OK-Button. [. . . ] However, as a special exception, the source code distributed need not include anything that is normally distributed (in either source or binary form) with the major components (compiler, kernel, and so on) of the operating system on which the executable runs, unless that component itself accompanies the executable. If distribution of executable or object code is made by offering access to copy from a designated place, then offering equivalent access to copy the source code from the same place counts as distribution of the source code, even though third parties are not compelled to copy the source along with the object code. You may not copy, modify, sublicense, or distribute the Program except as expressly provided under this License. Any attempt otherwise to copy, modify, sublicense or distribute the Program is void, and will automatically terminate your rights under this License. [. . . ]