User manual TELEFUNKEN TF 501 COSI

[. . . ] (See setting procedure) MOON PHASE NEXT TIDE TIME NEXT TIDE HEIGHT ALARM TIME ALARM TIDE DIRECTION GRAPH NOTE: SPECIAL FEATURES: 1. In any mode holding the light button for 2 seconds will return the watch to TIDE/DATE/TIME mode. We have given the TIDE/DATE/TIME mode a different key tone, this means even in the dark you can always find this mode. The LIGHT stays on for 3 seconds but if you continually press other buttons the light will stay on until a button hasn’t been pushed for 3 seconds. [. . . ] Once the calibration is complete DONE will appear in the screen and then the compass direction will appear. - To conserve battery life, after 60 seconds the Compass will revert to TIDE/TIME/ DATE MODE. Enter your OFFSET by using START/STOP or LAP/RESET then press MODE/SET to continue calibration. This means, take the watch off, hold it level, and rotate it SLOWLY in a clockwise direction. It will take one minute of slow clockwise rotation to complete the calibration. Once the calibration is complete, firstly DONE will appear in the screen and then the compass direction will appear. - To conserve battery life, after 60 seconds the Compass will revert to TIDE/DATE/ TIME MODE. cOMPASS (setting state) Magnetic North Deviation Calibration (B) B 60 sec Calibration successful (+ / - 45 degrees max. ) 2 secs 7 ***OFFSET – Entering the correct OFFSET makes the watch point to True North, OFFSETS vary for different places. Gov/seg/geomag/jsp/struts/calcDeclination NOTE: For accurate compass readings you re-calibrate your compass regularly or after it has come into contact with strong magnetic forces. ALSO NOTE: After calibration, compass readings should be taken away from large metal objects and appliances. Press START/STOP or LAP/RESET to toggle through tide data, one tide at a time, past or future, for the selected beach or use the procedure below for a distant future or past date. -HOLD START/STOP in for 2 seconds, the year will flash, press START/STOP & LAP/RESET to select the correct year. -Press MODE/SET the MONTH will flash in top left hand corner, press START/STOP or LAP/RESET to select the correct month. -Press MODE/SET the DATE will flash, press START/STOP & LAP/RESET to select the correct date. cHRONOGRAPH Chrono Lap 2 secs Lap Time TIMER (COUNTDOWN TIMER) SETTING -Press MODE/SET to advance to TIMER. Your watch timer is preset to 30 minutes, but can be adjusted to count down from 23hr 59min 59secs. Once the timer hits zero an alarm will sound for 30 seconds and the counter will then count upwards. -HOLD LAP/RESET in for 2 seconds to reset the Timer to the preset time. You must do this prior to being able to change the preset time of the timer. aDJUSTING TIMER TIME to another time period , up to 23hr 59min 59secs. -HOLD MODE/SET in for 2 seconds, the hour digits will appear and flash. [. . . ] €¢ If watch is exposed to salt water, rinse thoroughly in freshwater and wipe dry with a soft cloth. €¢ Do not clean watch with spray cleaners, thinners or other such volatile agents. €¢ Should moisture appear inside the watch, have it checked by Rip Curl technicians. €¢ Though Rip Curl watches are produced to high standards avoid dropping the watch and rough treatment. [. . . ]