User manual TECHWOOD PL73

[. . . ] · Consult your local store or an experienced radio/TV technician for help. · If you cannot eliminate the interference, the FCC requires that you stop using your system. Changes or modifications not expressly approved may cause interference and void the user's authority to operate the equipment. ! C AU T I O N : TO R E DUC E T HE R IS K OF E LE C T R IC S HOC K , DO NOT R E MOV E C OV E R OR B AC K . This symbol is intended to alert you to the presence of uninsulated dangerous voltage within the product's enclosure that might be of sufficient magnitude to constitute a risk of electric shock. [. . . ] o USING THE SLEEP TIMER You can set the sleep timer to turn off the receiver after a set period of time. Repeatedly press SLEEPon the remote control to set the sleep timer to the desired length of time ( 10, 20, 30, 40, 50, 60, 70, 80 , or 90 minutes). The receiver turns off when the selected time has expired. HOW TO ADJUST THE TONE To adjust the tone with the receiver press the TONE button on the PL73 until TONE ON appears in the display. While BAS 0dB is displayed use the or buttons on the receiver to increase or decrease the bass level. After you have set the bass level press the TONE button again and TRE 0dB will appear in the display. While TRE 0dB is displayed use the or buttons on the receiver to increase or decrease the treble level. Press the TONE button again until TONE ON appears in the display and wait until TONE ON is no longer displayed. To adjust the tone with the remote press the TONE button on the remote until TONE ON appears in the display. While BAS 0dB is displayed use the or buttons on the remote to increase or decrease the bass level. After you have set the bass level press the TONE button again and TRE 0dB will appear in the display. While TRE 0dB is displayed use the or buttons on the remote to increase or decrease the treble level. You can also adjust the channel output levels and speaker distances as described below. 3. To change the center speaker's level, repeatedly press or until you reach the desired level ( -10 to +10dB ). To change the front right speaker's level, repeatedly press or until you reach the desired level ( -10 to +10dB ). To change the rear right speaker's level, repeatedly press or until you reach the desired level ( -10 to +10dB ). To change the rear left speaker's level, repeatedly press or until you reach the desired level ( -10 to +10dB ). If the subwoofer has been turned on, to change the subwoofer's level, repeatedly press or until you reach the desired level ( -10 to +10dB ). This function allows you to configure the receiver for your Front, Center, Rear Surround and for a Subwoofer (SW). To change to F -LARGE, press N ote: I f floor standing speakers are used, choose F-LARGE. When using small speakers a powered subwoofer must be added to play low frequencies. N ote: If front speaker is set at F-SMALL, subwoofer cannot be set to SW-NO. Setting the Speaker Distance When you have arranged your home theater (speakers, receiver, and any components), you can change the speaker distance entered in the receiver's memory. Imagine a straight line from the front left speaker to the front right speaker. [. . . ] Speakers are connected wrong. Press DIMMER repeatedly to return to the default setting. After checking, if needed, reconnect. Power line of a fluorescent light is installed near this product. The speaker level is set to one side. Place this product as far away as possible from electric devices with interference. Adjust the speaker level. Sound cuts off or there Speaker impedance is less than prescribed After turning off the power and then turning it on again, for this unit. [. . . ]