User manual TECHWOOD MD59

[. . . ] 1) Read instructions - All the safety and operating instructions should be read before the product is operated. 2) Retain instructions - The safety and operating instructions should be retained for future reference. 3) Heed Warnings - All warnings on the product and in the operating instructions should be adhered to. 4) Follow Instructions - All operating and use instructions should be followed. [. . . ] VIDEO 2 : Press when playing a video component connected to this input. DVD/VIDEO 3 : Press when playing a video component connected to this input. SPEAKER selector buttons These buttons are used to select the speaker system "MAIN" or "SURROUND". LOUDNESS When listening at a low volume level, you can press this switch to boost bass. IMPORTANT : Never activate the loudness button when playing the stereo above the 50% volume level or damage will occur to your speakers and stereo. 7. Preset buttons (0 -9) These buttons are used to store and recall FM/AM stations in memory (See page 17). 20. BAND selector button Each time you press the button, the bands will change as follows. MEMORY button Use to store FM/AM stations in memory (See page 17). 17. MODE button Use to select the Normal Tuning Scan or Preset Channel scan modes. FM MODE button When activated, this unit automatically switches into the stereo mode when a stereo broadcast is received and the stereo light illuminates. The stereo indicator will not illuminate in the mono mode. 9 Display 1. (For use with matched compact disc changer CDC-85). 12 AUDIO OPERATIONS Back-up memory function BACK-UP memory This function stores the preset memory and most-recent memory functions. In the event of a power failure, or if the power cord of this unit is disconnected from the electric outlet, the back-up memory will save the preset memory and most-recent memory functions for approximately 3 days. If the power supply is interrupted for 3 days or longer, the memory settings will be erased. WHEN TO USE RESET SWITCH Ocassionally, the microprocessor inside the unit may malfunction due to electrical power surges or lightning storms. If the unit or display malfunctions, try resetting the microprocessor as shown. RESET SWITCH -Rear PANEL- Sleep Timer Operation SLEEP Timer Function This function allows you to preprogram the receiver to switch the power off automatically. You can enjoy the audio/video system for a specified amount of time without having to worry about turning the unit off later. Each press of the SLEEP button changes the time indication by 10 minutes. SLEEP 90 SLEEP 80 ··· SLEEP 10 Press the RESET switch lightly once or twice with a pencil or a ballpoint pen. Note : When the RESET switch is pressed, all the memory will be cancelled. IMPORTANT NOTE : The following applies through out the "AUDIO and VIDEO OPERATIONS" sections unless otherwise noted. To simplify explanations, instructions refer to names of buttons and controls on the front panel, making no mention of the use of remote control unit. To listen to a source other than tape deck, press the TAPE MONITOR button to the OFF position (the TAPE monitor indicator will not light in the display). (No timer setting) To determine how much time remains after the sleep timer has been set, press the sleep button again, the remaining time will be displayed. To turn the sleep timer off after it has been set, press the sleep button repeatedly until the timer counts down and the tuner display lights up with radio frequency. 13 Basic Operations Audio Adjustments 1. [. . . ] Set the TAPE MONITOR button to ON; the TAPE monitor indicator will appear in the display. Reter to the owner's manual included with the tape deck. 18 VIDEO OPERATIONS Playing Video Sources Recording with a Video Deck Tape Dubbing (from VIDEO 2 to VIDEO 1) 1. In this way, the video/audio signals from VIDEO 2 can be dubbed onto VIDEO 1. This feature will only operate if both video sources are properly connected to the STR-84. 1. [. . . ]