User manual TECHNICS SL-PG360A service manual

[. . . ] 21 ENGLISH E-1 PRECAUTIONS: READ THIS BEFORE OPERATING THIS UNIT . . . . . . . . . . . . · To assure the finest performance, please read this manual carefully. · Install this unit in a well ventilated, cool, dry, clean place with at least 5 cm of ventilation space on the top, right and left, and at the back of this unit ­ away from direct sunlight, heat sources, vibration, dust, moisture, and/or cold. · Locate this unit away from other electrical appliances, motors, or transformers to avoid humming sounds. To prevent fire or electrical shock, do not place this unit where it may get exposed to rain, water, and/or any type of liquid. [. . . ] · When making a digital recording, a new track marker is placed each time a new track begins on the source component. · When making an analog recording, spaces of silence are interpreted as track separations, and a new track marker is placed when a new audio signal is detected. Start playing the source. This unit automatically starts recording. 8. Once this unit has recorded 20 seconds of continuous silence, recording ends and "Wait" lights in the display while the disc information is being written to the PMA. 9. Finalization automatically starts after this writing is complete. · Press a to cancel finalization before the 20 seconds of continuous silence is reached. · Recording stops while the source is being played if there is no more recordable space on a disc, or 99 tracks have been already recorded. Once this unit has recorded 20 seconds of continuous silence, recording ends and "Wait" lights in the display while the disc information is being written to the PMA. After this writing is complete, this unit enters the stop mode. (See page 21 for the finalization procedure. ) ADDITIONAL INFORMATION Notes · Track numbers may not be correctly recorded depending on the source component. If the recording source has excessive noise or contains a lot of low level sound, track marking may not be properly performed without the silence being recognized. If the sampling frequency changes while making digital recordings from an external unit, this unit may fail to perform synchronized recording normally. Note · When making a synchronized recording after DISC A is selected using INPUT, track marking and ending are all performed based on the CD placed on disc tray A. Also recording can be done at double speed if necessary by changing the copy speed in the menu settings when DISC A is selected. · · ENGLISH E-17 RECORDING FUNCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Track and Disc Erase (CD-RW discs only) CD-RW discs can be erased and new recordings can be made after material has been erased. If the message "Check Disc" appears in the display during an erase operation and erasing stops, the disc may be damaged. Press ERASE until "Erase ALL?" appears in the display. · To cancel the Erase mode, press a. 3. Press w/d (w on the remote) to start All Track Erase. · This operation requires approximately 80 seconds. · During All Track Erase, "Erasing" appears in the display, and the approximate amount of elapsed time is displayed. 4. This unit enters the stop mode when erase is complete. E-18 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . RECORDING FUNCTIONS REC Mute REC MODE COPY TRACK NO. DISC A INPUT DIGITAL ANALOG MULTI JOG PUSH MODE FINALIZE ERASE I To change the fade-in and fade-out time GETTING STARTED 1. While this unit is in the record or stop mode, press and rotate the MULTI JOG knob (MENU and +/­ on the remote) to select "FadeIn time" or "FadeOutTime" in the set menu. DIGITAL REC LEVEL DISC B Recordable ReWritable 2. Press the knob (MENU on the remote) again and REC ANALOG REC LEVEL FADE IN/OUT MIN MAX REC MUTE rotate the knob (+/­ on the remote) to set the desired time between 1 and 10 seconds. 3. Press the MULTI JOG knob (MENU on the REC MUTE COPY remote) again to enter the time setting. This setting remains even when the power is turned off. RECORDING A OPEN/CLOSE B CD TEXT Copying and Editing REC MUTE FADE IN/OUT REC MUTE REC TRACK NO. WRITE REC MODE FINALIZE ERASE DISPLAY A/B This unit is CD TEXT compatible. [. . . ] Square optical connector jack ADDITIONAL INFORMATION I Outputs LINE OUT (PLAY) Type . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Pin jack Standard output level (1 kHz, 0 dB) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2. 0 ± 0. 5 Vrms DIGITAL OUT OPTICAL Type . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Square optical connector jack PHONES Standard output level (Input 150 ohms shorted, ­20 dB) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]