User manual TECHNICS SA-AX730

[. . . ] ) within the reach of children since these are a source of potential danger. The appliance must be installed by a qualified technician in compliance with the instructions provided by the manufacturer. The latter denies all responsibility for improper installation which may harm persons and animals and damage property. The electrical safety of this appliance can only be guaranteed if the latter is correctly and efficiently earthed, in compliance with regulations on electrical safety. [. . . ] 574 Distance to keep between the cut-out slot and the cabinet 56 0+ /- 1 49 0+ /- 1 40 mm min. 40 Technical characteristics Electrical connection • The electrical safety of this appliance can only be guaranteed if the latter is correctly and efficiently earthed, in compliance with regulations on electrical safety. If you have any doubts, call in a qualified technician to check the electrical system thoroughly. € The manufacturer denies all responsibility for damage resulting from a system which has not been earthed correctly. € Before powering the appliance, check whether the technical characteristics featured on the appliance data plate correspond with those of the mains electrical system. € Check that the current load of the mains supply and of the power sockets is suitable for the maximum power of the appliance, indicated on the appliance data plate. Disconnect the appliance from the electricity supply before all operations. Connect your hob to the electrical system by means of a junction box: if the appliance is connected permanently to the mains, an omnipolar circuit breaker, accessible if necessary, with a minimum contact opening of 3 mm should be installed. Valid only for models with a power supply cable Some models are supplied with a single-phase power supply cable, and should consequently only be connected to the singlephase mains. Collegamenti elettrici Tensione Frequenza Fusibili Sezioni To install the cable, proceed as follows: • unscrew the wire clamp screw and the contact screws. € to make the desired electrical connection (see table), use the jumpers housed inside the box. If you have locked the hob controls (see paragraph below), the same will still be locked when you turn the hob back on. The booster The booster is only fitted on hobs KBT8424 IDO 400 KBT8424 IDO - KOT7424 IO 400 - KOT7424 IO - KBT 7124 ID - KBT6114 ID - KBT6323 IO - KBT 6013 ID - KBT 6124 ID 400 - KBT 6124 ID - KBT 6104 I CL. KBT8424 IDO 400 - KBT8424 IDO - KOT7424 IO KBT6323 IO: you may programme all the cooking zones simultaneously for a maximum cooking time of 99 minutes. Proceed as follows: • select the cooking zone by pressing the corresponding control key, • set the desired heating power using the “+” and “-” keys, • press the programming key , • set the desired cooking time using the “+” and “-” keys, • confirm your programming by pressing the programming again. The end of programmed cooking is signalled by a beep (one minute long) and the cooking zone concerned is turned off. P er level ow 1-2 3 4 5-6 7-8 9 M umdurationof operation axim 10hours 5 hours 4 hours 3 hours 2 hours 1 hour Overheating protection device Should your appliance’s electronic components overheat, the hob will turn off automatically and “—” will come up on the power level display. The letter will disappear as soon as the temperature drops back down to an acceptable level. For the attention of wearers of pacemakers or other active implants: The hob complies with all current standards on electromagnetic interference. Your induction hob is therefore perfectly in keeping with legal requirements (89/336/CEE directives). It is designed not to create interference on any other electrical apparatus being used on condition that the apparatus in question also complies with this legislation. To avoid any interference between your induction hob and a pacemaker, the latter must be designed to comply with relevant regulations. [. . . ] The guarantee does not cover damage to the hob caused by incorrect use. € Always use pans whose diameter covers the cooking zone fully so that all the available heat can be used. € • • • Make sure the pan base is always clean and dry, to guarantee good contact and long life for the cooking zones and pans alike. The concentration of heat on gas burners can warp the bottom of the pan, consequently you would never obtain the desired result when using the pan on the glass ceramic hob. [. . . ]