User manual TECHNICS RS-1506

[. . . ] The exclamation point within an equilateral triangle and "CAUTION" are intended to alert the user to the presence of important operating instructions. Any function that requires your prolonged attention should only be performed after coming to a complete stop. Always stop the vehicle in a safe location before performing these functions. Return it to your authorized Alpine dealer or the nearest Alpine Service Centre for repairing. [. . . ] The frequency on the display continues to change while the automatic memory is in progress. When the automatic memory has been completed, the tuner goes to the station stored in the preset location No. NOTE If no stations are stored, the tuner will return to the original station you were listening to before the auto memory procedure began. The RDS allows you to receive a variety of information such as traffic information, station names, and to automatically re-tune to a stronger transmitter that is broadcasting the same programme. The F button changes to green (CDM-7857RB/ RS-1506/CDE-7854R/CDE-7853R), orange (CDE-7854RM). NOTE When the BAND button is pressed and held for more than 2 seconds while a station name is displayed, the display shows the station frequency for 5 seconds. The F button changes to green (CDM-7857RB/ RS-1506/CDE-7854R/CDE-7853R), orange (CDE-7854RM). Make sure that the F button lights red, then press the preset location button in which your desired RDS station is preset. If the preset station's signal is weak, the unit automatically searches and tunes to a stronger station in the AF (Alternative Frequencies) list. If the preset station and the stations in the AF list cannot be received: The unit searches again for a station in the PI (Programme Identification) list. If there are still no stations receivable in the area, the unit displays the frequency of the preset station and the preset indicator disappears. If the station being received does not broadcast the traffic information, the receiver automatically tunes in the related station that broadcasts the traffic information when it occurs. Press and hold the PTY button for at least 2 seconds to activate the PTY mode. The Programme Type of the station being currently received will be displayed for 5 seconds. NOTE If a CD Changer is connected and the RPT ALL mode is selected, the unit repeatedly plays back all tracks on the disc selected. to stop scanning , press the SCAN button to deactivate the Scan mode. NOTE In case a 6-disc CD changer is connected (CDM7857RB only): Press the F button to change to green, then go to step 1. NOTE In case a 6-disc CD changer is connected (CDM7857RB only): Press the F button to change to green, then go to step 1. If an optional Alpine 6-disc CD Changer is connected to the 8-pin DIN connector (M-Bus) of the CDM-7857RB, you can control the CD Changer using the CDM-7857RB. NOTE The CD controls on the CDM-7857RB for the CD Changer operation are functional only when the CD Changer is interconnected with the CDM-7857RB. After all the tracks on the disc have been played back once, the player will begin a new random sequence play until the M. NOTE In case a 6-disc CD changer is connected (CDM-7857RB only): Press the F button to change to green, then go to step 1. [. . . ] This can be done by pressing firmly in on the unit while pushing the locking pin down with a small screwdriver. This ensures that the unit is properly locked and will not accidentally come out from the dashboard. 2 Use a small screwdriver (or similar tool) to push the locking pins to the "up" position (see Fig. As each pin is unlocked, gently pull out on the unit to make sure it does not re-lock before unlocking the second pin. [. . . ]