User manual TEAC W-865R

[. . . ] Quick stops, excessive force, and uneven surfaces may cause the product and cart combination to overturn. 10) Ventilation -- Slots and openings in the cabinet are provided for ventilation and to ensure reliable operation of the product and to protect it from overheating, and these openings must not be blocked or covered. The openings should never be blocked by placing the product on a bed, sofa, rug, or other similar surface. This product should not be placed in a built-in installation such as a bookcase or rack unless proper ventilation is provided or the manufacturer's instructions have been adhered to. [. . . ] When one tape is played back to the end, the other tape automatically starts playback, in a relay fashion. The Blank Scan function detects 10 seconds or more of blank and skips over it. To activate this function, press the BLANK SCAN button followed by the desired play button (h or y). Always set the Dolby NR switch to the same position that was used for recording. < Very quiet passages in music are likely to be identified as blanks. 4 Press the play button (h or y) of the deck you want to You can start continuous playback from either TAPE I or TAPE II. Playback will automatically stop when both sides of both tapes have been played back 5 times continuously. This cassette deck is equipped with the Computomatic Program Search (CPS) function. This function detects blank spaces (longer than 4 seconds) between songs and fast-winds the tape in the forward or backward direction skipping over the specified number of songs, thus allowing direct access to the beginning of a desired song. When you press the m or , button during playback, the tape counter reads "CP 01" and the tape starts running at high speed in the pressed direction. Each time you press the same direction button, the displayed number increases by one integer. < If you are listening to a song and want to go back to the previous song, press the locator button opposite to the playback direction twice. Pressing it just once will take you back to the beginning of the current song. U: Only one side of tape j: Both sides of the tape when searching in the same direction as playback OR Only one side of the tape when searching in the opposite direction as playback p: Both sides followed by the first side (side "A" w side "B" w side "A" if CPS is started when the tape's forward side (facing you) is playing; or side "B" w side "A" w side "B" if CPS is started when the tape's reverse side (facing away) is playing) < The CPS function may not work properly if blanks between songs are less than 4 seconds long or contain noise. Intro Check plays the first 15 seconds of each song, allowing you to quickly find the song you are looking for. When you find the desired song, press the INTRO CHECK button again to start playback. < Make sure that the TAPE I compartment is empty when starting Intro Check on TAPE II. < The tape counter reports how many songs have been introchecked so far. ENGLISH < Activating the Intro Check function during normal playback will cause it to skip to the next song: playback of the current song is interrupted midway. < The Intro Check function may not work properly if blanks between songs are less than 4 seconds long or contain noise. The Intro Check range varies depending on REV MODE switch settings: u: Checks one side of the tape j: Checks both sides of the tape p: Checks both sides of tape then double checks the first side (side "A" w side "B" w side "A" if Intro Check is started on the tape's forward side (facing you); or side "B" w side "A" w side "B" if Intro Check is started on the tape's reverse side (facing away) The tape automatically stops upon completion of the check operation. Insert the cassette tape with its open edge facing down, side "A" facing you. [. . . ] E If the remote sensor of the deck is exposed to direct sunlight or very bright light, the remote control may not work. If this is the case, use the control buttons of the deck itself instead. Noisy playback e Keep away from equipment that generates a magnetic field, such as a TV or microwave oven. E If the erasure prevention tabs on top of the cassette are broken off, cover the holes using pieces of adhesive tape. [. . . ]