User manual TEAC T-R670

[. . . ] 3) Heed Warnings -- All warnings on the product and in the operating instructions should be adhered to. 4) Follow Instructions -- All operating and use instructions should be followed. 5) Cleaning -- Unplug this product from the wall outlet before cleaning. 6) Attachments -- Do not use attachments not recommended by the product manufacturer as they may cause hazards. [. . . ] F ) when the product exhibits a distinct change in performance _ this indicates a need for service. 21) Replacement Parts -- When replacement parts are required, be sure the service technician has used replacement parts specified by the manufacturer or have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock, or other hazards. 22) Safety Check -- Upon completion of any service or repairs to this product, ask the service technician to perform safety checks to determine that the product is in proper operating condition. 23) Wall or Ceiling Mounting -- The product should be mounted to a wall or ceiling only as recommended by the manufacturer. 24) Heat -- The product should be situated away from heat sources such as radiators, heat registers, stoves, or other products (including amplifiers) that produce heat. (General export models only) Be sure to remove the power cord from the AC outlet before repositioning the voltage converter switch. Using a flat-bladed screwdriver, set to the appropriate 230V or 120V position according to your area. Also avoid locations subject to vibrations and excessive dust, heat, cold or moisture. < Do not open the cabinet as this might result in damage to the circuitry or electrical shock. < When removing the power plug from the wall outlet, always pull directly on the plug, never yank the cord. < Do not attempt to clean the unit with chemical solvents as this might damage the finish. Extend this into a "T" shape and connect the two wires at the base of the "T" to the provided matching transformer, as shown. After completing connection, plug the transformer into the "FM 75" socket. Extend the top of the "T" and fix with thumb tacks, or the like, to a wall or window frame for the best possible reception. In an area where FM signals are weak, it will be necessary to use an outdoor antenna with 3 or more elements. If you are using a 300-ohm antenna, connect it to the tuner via the supplied matching transformer. A high-performance AM loop antenna provided with the tuner is sufficient for good reception in most areas. Snap the supplied loop antenna into the hinge on the rear of the unit, and connect the wires running out the loop antenna to the AM terminals, as shown. When you actually try listening AM programs later, you may want to turn the loop antenna on the hinge for the best possible reception. If the AM loop antenna provided does not deliver sufficient reception (because you are too far from the transmitter or in a concrete building, etc. Use an insulated wire more than 15 ft (5 m) long, strip one end, and connect this to the terminal as shown. [. . . ] A red indication, TIMER, appears in the lower left corner of the display to indicate that the tuner is put under the control of the timer. To check the current timer settings, press the TIME SET button twice, then press the MEMORY/SET button. If you are happy with the current ON-TIME setting, press the TIME SET button once, followed by the MEMORY/SET button, to check the OFF-TIME setting. To release the tuner from the control of the timer, simply press the TIMER button to turn off the TIMER indicator in the display. [. . . ]