User manual TEAC QUICK DV516EENG

[. . . ] TEAC DV-516E DVD-ROM Drive Quick Installation Guide Drive Installation Directions There are three possible positions for installation: Horizontal installation with the eject button to the right, and vertical installation in both possible directions. The installation position is not allowed to be tilted more than ±5 degrees out of the vertical or horizontal position. [. . . ] The TEAC DV-516E can be operated in the modes Cable Select (CS), Master (MA) or Slave (SL). Note: To use the TEAC DVD-ROM drive an IDE (ATAPI) controller is required. The drivers required for operating the DVD-ROM drive are a part of your operating system. Usually there is also a 40 pin flat ribbon cable available at each of the connectors. Regardless if the two drives are connected to the primary or the Installation and Connection Very important: Switch off your PC and any attached devices and disconnect the power cord(s). (3) Locate a free half-height-drive slot for 13. 3cm/5. 25" drives. Carefully slide the drive into the opening so that the disk tray shows at the front of the computer. It may be easier to connect the cables first before you push the drive fully into the slot and to fix it with screws. TEAC DV-516E DVD-ROM Drive Quick Installation Guide (4) Connect the power cable and the 40-pin data cable (assure the correct orientation, pin 1 is often marked with a color stripe) to the drive. Connecting in the wrong orientation may damage the drive and the PC! page 2 Do not clean the inner parts of your TEAC DVDROM drive with compressed air. Any of these methods may cause damage to your TEAC DVD-ROM drive. Software Installation Audio cable DV-516E Windows 95/98/ME/2000/XP do not require a software installation. Important: The TEAC DV-516E cannot be used with DOS. Pin 1 Care and Handling Do not expose your DVD-ROM drive to extreme temperatures, excessive dust or high humidity. Do not install your DVD-ROM drive near any device that produces strong electrical waves or magnetic fields. [. . . ] This DVD-ROM drive can be changed to play a DVD from any region in the world but can only be changed five (5) times. This restriction makes the drive adaptable for use in any region while still maintaining compliance with RPC-II regulations. In case of warranty: www. teac. de/support/german/index. htm [. . . ]