User manual TEAC QUICK CD-W552PUK

[. . . ] TEAC CD-W552PUK CD-RW Drive Quick Installation Guide With a reading speed factor of approx. It is able to write to CD-R media with a writing speed of 4X, 8X, 12X, and 16X (CLV mode), of 24X, 32X, and 40X (partial CAV mode) and it is able to write to CD-RW media with a writing speed of 2X, 4X, 8X, 10X, 12X and 16X (CLV mode), and of 24X (partial CAV mode). Very important: TEAC assumes no responsibility for data loss caused by the operation that is not in accordance to this document, or data loss caused by natural disaster, fire, power outage, or spontaneous defect of this product. [. . . ] The following logo is usually indicated near the USB terminal. Insert the A plug of the USB connector to the USB terminal of the computer. (5) If the driver was found (TTP300. INF for USB2. 0; TTPSL11R. INF for USB1. 1), click on Next. (6) After sucessfully finishing the installation the hardware assistant is closed with Finish. Important: If an error message appears you may move one step backwards or cancel the process (using Cancel) and try it again later. If installation of the driver fails you will see in the device manager an exclamation mark (!) or a question mark (?). Remove the driver and start the installation process again. (6) There appear some messages on the screen followed by the appearance of an CD-ROM icon in the window My Computer. Very important: When you are using Windows 98SE and the drive is connected for the first time, it is required to read and install the device driver file from the provided CD. Disconnecting the drive The drive can be disconnected from the PC if it is not used any longer during the actual session. It is of major importance to logoff the drive at the PC before disconnecting it. (3) Click the Remove icon on the Taskbar. Driver installation under Windows98SE (1) Connect as described before the dedicated AC adapter to the drive, then connect the USB interface cable between the drive and your computer. (3) Ensure your driver CD is inserted correctly into a CD-ROM drive and select "Search for the best driver for your device (Recommended)". (4) When specifying the location to search the driver, select "CD-ROM drive" or check "Specify a location" and input the location of the driver folder if you have saved them in advance on your computer (The window below is an example if the folder CDW552PU in drive C: is specified). Click Next. (4) Select the removing drive with the name assigned to the drive. (5) The Remove Hardware confirmation message , , Save to remove storage device" appears. (6) Remove the plug of the USB cable from the USB terminal of the computer. page 2 Important: Do not disconnect the power cord or the USB cable which connects the PC and the drive without carrying out the logoff procedure. Otherwise this may lead to loss of data and erroneous operation of the PC. Important: If liquid is allowed to poor into the drive, it may cause a serious malfunction, an electric shock or a fire. When cleaning with liquid, be sure to remove the provided AC adapter from the wall outlet after disconnecting the drive from your computer. Important: Do not use cleaning CDs which will remove dirt of the lense of the laser aided by a little brush. [. . . ] Refer to the operation manual of your computer or software for details. Cleaning and maintenance of your TEAC USB CD-RW drive TEAC drives will not need maintenance if used as specified in this manual. Usually there are only problems with dirty or defective CDs. page 3 Specifications Applicable disc format CD-DA, CD-ROM Mode-1, CD-ROM XA Photo CD multi-session, CD-TEXT CD-I, Video CD, CD Extra (CD Plus) CD-ROM, CD-DA CD-R, CD-RW 12 cm, 8 cm Applicable disc type Type Size An actual list of media recommended by TEAC can be found at TEACs web site under www. teac. de/support. Interface USB1. 1 / USB2. 0 (High Speed) Data rate Data transfer speed CD-ROM read 52 x CAV USB1. 1: 1. 5MB/s = 12Mbit/s USB2. 0: 60MB/s = 480Mbit/s 7, 800 KB/s (maximum at 52 x) CD-ROM (Mode-1) CD-ROM XA CD-DA (Digital Audio Extraction) CD-RW, Video CD CD-Audio, Video CD 7, 800 KB/s (maximum at 52 x) 52 x CAV, 40/32/24 x Partial-CAV, 16/12/8/4 x CLV 24 x Partial-CAV, 16/12/10/8/4/2 x CLV Disc-at-once, Session-at-once, Track-at-once, Packet write 140 ms (average) 2MB Line out: 0. 7Vrms±0. 02Vrms (at load of 130 Ohm typ. ) ear phone (ø3. 5mm stereo mini jack): 1. 33Vrms±0. 12Vrms (at load of 132 Ohm typ. ) primary: 240V/110V 50/60Hz 850mA secondary: 5V/2. 5A, 12V/1. 5A 5°C to 45°C -20°C to 60°C 8% to 80% (non-condensing) 15% to 85% (non-condensing) CE 167 (W) × 55 (H) × 273 (D) mm 1. 85 kg (without AC adapter and interface cable) Changes in specifications and features may be made without notice or obligation. 32 x CAV 8 x CLV Write speed CD-R/RW write CD-R CD-RW Write mode Access time Data buffer Audio out Power consumption Environmental condition Temperature Relative humidity Safety standards Dimensions Weight Operating Non-operating Operating Non-operating Warranty is provided under the terms of the TEAC warranty conditions. [. . . ]