User manual TEAC PD-D2610

[. . . ] The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. Note to CATV system installer: This reminder is provided to call the CATV system installer's attention to Section 820-40 of the NEC which provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical. 1) Read Instructions -- All the safety and operating instructions should be read before the product is operated. 2) Retain Instructions -- The safety and operating instructions should be retained for future reference. [. . . ] < Do not stick papers or protective sheets on the discs and do not use any protective coating spray. MP3 CDs Note: < Depending on the quality of the disc and/or the condition of the recording, some CD-R/CD-RW discs may not be playable. < Copy-protected discs and other discs that do not conform to the CD standard may not play back correctly in this player. If you use such discs in this unit, TEAC Corporation and its subsidiaries cannot be responsible for any consequences or guarantee the quality of reproduction. If you experience problems with such non-standard discs, you should contact the producers of the disc. < Use a soft oil-based felt-tipped pen to write the information on the label side. Never use a ball-point or hard-tipped pen, as this may cause damage to the recorded side. Using commercially available CD stabilizers with this unit will damage the mechanisms and cause them to malfunction. < Do not use CDs with an irregular shape (octagonal, heart shaped, business card size, etc. CDs of this sort can damage the unit: (Compact discs can be played or recorded only on one side. ) < To remove a disc from its storage case, press down on the center of the case and lift the disc out, holding it carefully by the edges. < If you are in any doubt as to the care and handling of a CDR/CD-RW disc, read the precautions supplied with the disc, or contact the disc manufacturer directly. < Even if the remote control unit is operated within the effective range, remote control operation may be impossible if there are any obstacles between the unit and the remote control. < If the remote control unit is operated near other appliances which generate infrared rays, or if other remote control devices using infrared rays are used near the unit, it may operate incorrectly. During playback, use these buttons to search the part you want to listen to. Make sure that the batteries are inserted with their positive "+" and negative "_" poles positioned correctly. Battery Replacement If the distance required between the remote control unit and main unit decreases, the batteries are exhausted. < Be sure to insert the batteries with correct positive "+" and negative "_" polarities. < When the remote control unit is not to be used for a long time (more than a month), remove the batteries from the remote control unit to prevent them from leaking. If they leak, wipe away the liquid inside the battery compartment and replace the batteries with new ones. < Do not heat or disassemble batteries and never dispose of old batteries by throwing them in a fire. CAUTION: < Switch off the power to all equipment before making connections. [. . . ] When all tracks/files have been played once, the unit will stop playback. < If the INTRO CHECK, REPEAT and SHUFFLE buttons are all pressed, the first 10 seconds of tracks/files are shuffle played. When shuffle intro play of a disc is once over, the next disc will start playing. The 10 seconds of all tracks/files on all discs are thus continuously shuffle played. [. . . ]