User manual TEAC MC-DX32I

[. . . ] Includes adapters for: iPod nano iPod with video iPod mini iPod with Click Wheel iPod with color display Adapters sold separately: iPod with dock connector The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. Note to CATV system installer: This reminder is provided to call the CATV system installer's attention to Section 820-40 of the NEC which provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical. 1) Read Instructions -- All the safety and operating instructions should be read before the product is operated. 2) Retain Instructions -- The safety and operating instructions should be retained for future reference. [. . . ] Use an RCA (pin) video cable to connect the Dock to the composite video connector of a television or monitor. Use an S-Video cable to connect the Dock to the S-Video input of a suitably equipped television or monitor. < If not using the included speakers, make sure the speakers you use are at least 4 impedance. Note: To simplify explanations, instructions in this manual refer to the names of the buttons and controls on the front panel only. In Standby mode, these buttons are used to set or adjust the clock and the timer. Use this button and the VOLUME buttons to adjust the level of high frequency sound range. When the main unit is in the standby mode, the power indicator of the Subwoofer is orange. Use this button and the VOLUME buttons to adjust the level of low frequency sound range. In iPod or CD mode, use this button to turn on and off the shuffle playback. Precautions < Be aware that the length of the cables are approximately 3 m. < Drill holes into solid wall support, such as wooden frame or concrete wall. < TEAC supplies these brackets as a convenience to the product owner. Consult your local building codes and exercise all necessary caution when mounting these brackets. If you are unsure how to use the supplied brackets, consult with a local tradesmen or building supply expert. The provided Remote Control Unit allows the unit to be operated from a distance. When operating the remote control unit, point it towards the remote sensor on the front panel of the unit. < Even if the remote control unit is operated within the effective range, remote control operation may be impossible if there are any obstacles between the unit and the remote control. < If the remote control unit is operated near other products which generate infrared rays, or if other remote control devices using infrared rays are used near the unit, it may operate incorrectly. Fix the brackets on the rear panel of the speakers using the supplied short screws. < As a convenience , a set of tapered plastic anchors is supplied. If you chose to use these anchors, drill a pilot hole using a 6 mm drill bit then tap the anchor into the pilot hole. Only use these anchors if they are appropriate for the materials onto which the unit is to be mounted. [. . . ] < The unit can be programmed to turn on and off at a specified time. Seconds and release it when the "hour" value starts blinking. To turn on or off the timer When you don't use the timer, press the TIMER button to turn it off. < When the timer is turned on, the timer settings are displayed one by one, and the TIMER indicator lights on the display. [. . . ]